Figure 6-7: Static Table; Figure 6-8: The Setup Tab - Vlan - Linksys WRV200 User Manual

Wireless-G VPN Router with RangeBooster
Start IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. This value must be
192.168.1. 2 or greater, but smaller than 192.168.1.254, because the default IP address for the Router is
192.168.1.1, and 192.168.1.255 is the broadcast IP address.
Number of Address. Enter the maximum number of PCs that you want the DHCP server to assign IP addresses
to. This number cannot be greater than 253. In order to determine the DHCP IP Address range, add the starting IP
address (e.g., 100) to the number of DHCP users.
IP Address Range. The range of DHCP addresses is displayed here.
Client Lease Time. This is the amount of time a DHCP client can keep the assigned IP address before it sends a
renewal request to the DHCP server.
The Static Table shows the mapping of MAC addresses to IP addresses. To use this feature, enter the Static IP
Address and MAC address in the fields, then click Add. To edit an entry, highlight the entry in the table, click the
Edit button, make your changes in the fields, then click Add. To remove an entry, highlight the entry, then click

Figure 6-7: Static Table

Remove.
Manual DNS Setting. To enter the DNS IP addresses manually, enter up to two in the fields provided.
Time Setting
This is where you set the time for the Router. You can set the time and date manually or automatically.
Manually. Select the date from the Date drop-down menus. Then enter the time in the Time fields.
Automatically. Select your time zone from the Time Zone drop-down menu. If you want to enable the Automatic
Daylight Savings feature, click the Enabled radio button.
When you have finished making changes to the screen, click the Save Settings button to save the changes, or
click the Cancel Changes button to undo your changes.
The Setup Tab - VLAN
The Router provides a port-based VLAN feature.
Port-based VLAN. Select Enabled to enable the feature. When enabled, and a VLAN is selected, VLAN1 will be
enabled as a default VLAN, so you will have two VLANs. Select Disabled to disable the feature. When this feature

Figure 6-8: The Setup Tab - VLAN

is disabled, all LAN ports are on the same LAN.
Number of VLAN. Select the number of the VLAN from the drop-down menu.
Chapter 6: Configuring the Wireless-G VPN Router 20
The Setup Tab - Basic Setup