D S35 User Manual page 6

• Wipe off the defrosted water.
Never use hard or pointed tools to remove ice or to loosen objects which have frozen in
place.
6.TOUBLESHOOTING
Issues Cause/Suggestions
Refrigerator does not work
• Check if the switch is on.
• Check if the plug and socket are connected well.
• Check if the fuse has been burnt.
• Check if the power supply is malfunctioned.
• Switch on/off the fridge frequently may cause start delay of the compressor.
Refrigerator compartments are too warm
• The door is opened frequently.
• A large amount of warm or hot food was stored recently.
• The refrigerator has been disconnected for a long time.
Food is frozen
• The temperature was set too low.
There is "water flow" noise from inside the refrigerator
• It's a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops around the refrigerator casing or door gap
• It's a normal phenomenon, the moisture will condense to water when it touches a cold
surface of the refrigerator.
The compressor is slightly noisy when starting
• It's a normal phenomenon, the noise will be reduced after the compressor works stably.
Code F1 displayed
• Possible cause: low voltage to fridge. Adjust the battery protection from High to Medium
or from Medium to Low.
Code F2 displayed
• Possible cause: condenser fan is overloaded. Disconnect power to fridge for 5 minutes
& re-start. If the code shows again, contact manufacturer for service.
Code F3 displayed
• Possible cause: the compressor starts too frequently. Disconnect power to fridge for 5
minutes & re-start. If the code shows again, contact manufacturer for service.