BARIX SilenceMonitor M400 Flexa Quick Install Manual

Quick Install Guide
Welcome to the Silence Monitor Quick Install Guide! With this Document, you should be able to quickly set up your device and get it
running inside your environment!
Safety Precautions: Please make sure to first read the safety information in order to avoid hazards (see

1 Package Content and Prerequisites

SilenceMonitor M400 Flexa device
Power Supply
RCA Analog Audio cables
Rubber Feet
Ethernet cable (not included)
Headset (optional, not included)

Compatibility
The Silence Monitor Solution requires an M400 Flexa device.
Doing the following steps in the given order is recommended but is not mandatory!

2 Setup the Silence Monitor Portal

Sign-up or Login to the Silence Monitor Portal!
To receive Notifications from your Device, it will need to be registered to the Silence Monitor Portal! After creating your account or
login-in to your existing one, you can Add devices to your account by clicking on Add Device.
To Add your device you will need to enter the Registration-ID of the device (RID, 12 Character), which is displayed on the back of the
device or can be found on the Web Interface of the Device. Name the device and select a timezone, then click "Add Device".
When clicking on "Add Device", the device will be added to your account with a free 3 days trial! At this point, the device needs to be
synced with the portal, described in the Next section "Device Installation"!

3 Device Installation

Connect your Silence Monitor Device to a Network cable, connect the Audio Inputs and Power the device! Make sure that the
Network is connected to the Internet!
BARIX AG | Ringstrasse 15 A | CH-8600 Dübendorf | T + 41 43 43322 11 | www.barix.com
here).
Page 1/ 4