Star Headlight & Lantern DLQSMC-ARO Manual

Multi-Colored Quick Stick Arrow Board
DLQSMC-ARO
DLQSMC-ARO2

Mounting Instructions

Prior to mounting the light, determine
the path your cable will take. The cable
should exit the left side when you are
facing the lights on the arrowstick
mounted on the rear of the vehicle.
1. There is a slot along the length of the back of the
arrowstick that should be used to facilitate mounting.
Insert the heads of the two enclosed #10 carriage bolts
into the hole in the slot.
2. Slide them along the channel to the desired location and
mark the locations for your mounting holes on the
mounting surface.
3. Drill your holes and mount the light using the enclosed
washers and nuts.
We also include two L-Brackets to facilitate mounting.
These are optional and do not need to be used.
PLIT620 REV. B 11/2/22

Electrical Connections

This wiring diagram below applies to the default programming of this light. There are
several additional advanced features that, if used, will affect the wire functions
shown below. Most applications will not require this reprogramming, but you can
find these options described in detail under the Advanced Programming section.
Use standard On/Off switches rated for 5 amps and make your connections
according to the wiring diagram below.
Default Wiring Setup
(Wire Setup 1)
The RED wire must be connected to +12VDC
for any of the functions to work.
RED - Power
PINK - Steady Burn Tips
(Color 2 - Head Groups 1 & 8)
WHITE w/BROWN - Left Arrow
(Color 1 - Head Groups 1-6)
GREEN w/YELLOW - Right Arrow
(Color 1 - Head Groups 3-8)
ORANGE w/RED - Color 1 Full Warn
YELLOW - Color 2 Full Warn
RED w/GREEN - Pattern Select
BLACK - Ground
1 8
7
2
3 4 5 6 6
3 4 5
2
7
Head Groups
1
8
Note: The wires are shown above in order of Priority. Higher priority wires will override
the patterns on any lower priority wires for the heads that are enabled.
HIGHEST PRIORITY
Pink > White w/Brown > Green w/Yellow > Orange w/Red > Yellow
Function
Wires
Left Arrow
Both=Center-Out
Right Arrow
Function
Wires
Ignition-Switched Relay
10 AMP Fuse
**Standby current < 0.001A
12VDC BATTERY
LOWEST PRIORITY
-2-