Table of Contents
Advertisement
Mounting the Antenna with the Cable Routed Through the Pole
Before you permanently mount the antenna, you must test the mounting location for correct operation
the Mounting Location,
page 3).
1 Position a standard 1 in. OD, 14 threads per inch, pipe-threaded pole (not included) in the selected location,
and mark the approximate center of the pole.
3
2 Use a 19 mm (
/
in.) drill bit to drill a hole for the cable to pass through.
4
3 Fasten the pole to the boat.
4 Thread the pole-mount adapter onto the pole.
Do not overtighten the adapter.
5 Route the cable through the pole and connect it to the antenna.
6 Place the antenna on the pole-mount adapter and twist it clockwise to lock it in place.
7 Use the included M3 set screw and a 1.5 mm hex wrench to secure the antenna to the adapter
8 With the antenna installed on the pole mount, fill the vertical cable slot
9 Route the cable away from sources of electronic interference.
.
with a marine sealant (optional).
(Testing
5
Advertisement
Table of Contents
