Advertisement
How To Service The Dropsides
Refer to the
separate Dropside
How To Remove The Plastic Base Cover
1. Fully raise the height of the stretcher top.
2. Lift the plastic base cover up and then twist/roll it sideways.
3. Slide the entire cover out of the base frame through the lifting legs.
4. To replace, follow reverse procedure.
How To Replace The Lifters
1. Firstly ensure the base cover is free and then lay the stretcher on its side on the ground. This can
be done by the following steps;
2. Stand facing the side of the stretcher – the side to stand on must be the side that you want to
have lain down on the ground.
3. Pull stretcher towards you until all castors are at 90° to the length of the stretcher (facing away
from you) and apply the brakes.
4. With the help of another person, firmly hold end rails at either end of the stretcher and carefully
tilt it over until top makes contact with the ground.
5. Remove the retaining pins from the ends of the lifter.
6. Replace with new lifter ensuring that the new one is positioned correctly.
7. Reassemble in the reverse order to the steps above.
v-12112022 - Page 3
Servicing guide.
"Trusted products made for trusted professionals"
Advertisement
