Quoizel DRS8407EK Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Fixture can only be mounted in the direction indicated on page 2.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
A
Alternate
B Mounting screw
x 2
Tab
C
x 4
-
STEP 1 Remove Arm and Cage
A. Unlock lock balls in the bottom edge
of the cage and remove the arm from
the Fixture Body (E).
B. Unscrew screws on the top edge of
the cage and remove the cage from
the Fixture Body (E).
-
STEP 2 Install Bulb
A. Insert the bulb onto the socket
and screw snugly into place.
Figure 2
2019 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Crossbar
Assembly
x 1
Fixture Body
E
Glass Panel
x 1
D
x 4
Figure 1
Socket
Vintage Bulb
(recommended
but not included)
visit us on-line at www.quoizel.com
Installation Guide #IS-DRS8407EK
For Style DRS8407EK
Care + Maintenance selection.
-
STEP 3 Install Glass Panels
A. Place the Glass Panel (D) into the slot
in the bottom edge of the cage. Secure
the Glass Panel (D) by pressing the
Tab (C) onto the top edge of the Glass
Panel (H) and the slot on the top edge
of the cage.
-
STEP 4 Install Cage and Arm to
Arm
Fixture Body
A. Place the cage over the bulb, attach
to the fixture hood on the Fixture
Body (E) and secure with previously
removed screws. Hand tighten until
snug with screwdrivers.
E
B. Place bolts on the bottom end of the
arm to holes on the bottom edge of
the cage and secure with previously
removed lock balls. Hand tighten
until snug.
Screw
Cage
Lock Ball
1of3
Figure 3
Bolt
Figure 4
Lock Ball
ReleasedDate:2019-03-15
C
D
Slot
Cage
Slot
Arm
E
Screw
Cage
Hole