Ignition connection table
Ignition system
Connection point (Orange wire)
Coil & Points
Coil Negative (Low tension)
HEI systems
Coil Negative (Low tension)
Magneto (Ext. or Int)
Ground switch terminal (magneto side)
MSD
Tachometer output
Magneto CD (2 stroke)
Use HT pick up (ST697)
Stack Shift Light connection (optional)
0.2 Amps.
0.2 Amps.
0.2 Amps. Exceeding this will
0.2 Amps.
acho.
acho.
acho.
acho.
demonstration mode
. . . . .
and apply power to the tachometer.
X
. . . . .
when the pointer has stopped resetting on the stop pin.
. . . . .
to select the number of cylinders - the pointer
2W Max
Red
12V
Black
will will
will will
Blue wire
from Tachometer
. . . . . If you power up the
j j j j j
3 seconds
Normal Operation
When power is applied to the tachometer, the pointer will reset moving backwards
against the stop before moving to the current RPM (Zero RPM if the engine is not
running). When power is removed, the pointer is held at its' last position (it doesn't
necessarily return to zero)
Tell Tale Memory
Recall
To
the Tell Tale Memory
. . . . .
The pointer shows the highest RPM seen since the memory
was last reset
Note: The Tell tale will be remembered even when the power is off.
Reset
To
the memory
The pointer will initially move to the highest RPM value, then
. . . . .
after 5 seconds the needle will move to the full scale of the dial
j j j j j
and sweep down to zero.
Only when the pointer reaches zero will the memory be
reset
.
5
Hold
seconds
Now the switch can be released .
. . . . .
X
Note: If the switch is released before the pointer reaches
zero the memory will NOT be reset.
Shift-Light set up (optional)
Adjust
Adjust
To Adjust
Adjust the Shift-RPM setting
Adjust
Press and hold the switch as if you were to reset the Tell Tale
. . . . .
memory (see section above).
j j j j j
When the pointer sweeps down to zero - resetting the Tell Tale
memory, continue holding the switch for a
Hold
14
seconds
The pointer will then move to the current setting for the Shift-
RPM.
Release the switch. Now each time the switch is pressed or
. . . . .
held on the pointer will increment 50 RPM. If the pointer
reaches full scale it will return to zero and start to increase
again.
When the desired Shift-RPM has been reached, release the
. . . . .
X
switch and wait
j j j j j
indicating that the Shift-RPM has been set.
Note: The Shift-RPM will be remembered even when the power is off.
3
Wait
seconds
.
further 5 seconds
3 seconds
. The pointer will then move to zero,
.
Need help?
Do you have a question about the Clubman ST200 and is the answer not in the manual?