Table of Contents
Advertisement
Starting
•
Start according to instructions in this manual or on the
machine.
•
Before attempting to start the engine, make sure the
bail is released.
•
When starting the engine, make sure hands and feet
are clear of the blade.
•
Do not change engine governor settings or overspeed
the engine. Operating the engine at excessive speed
can increase the hazard of personal injury.
Operating On Slopes
Use Extra Care When Working On Slopes
•
Do not operate on slopes if uneasy or uncertain. Ulti-
mate responsibility for safe operation on slopes rests
with the operator.
•
Do not operate on steep slopes.
•
Keep all movement on slopes slow and gradual.
•
Do not operate near drop-offs, ditches or embank-
ments. The machine could suddenly turn over if a
wheel runs over the edge or an edge caves in.
•
Do not turn on slopes unless necessary, and then turn
slowly and downhill when possible.
•
Be sure of your footing on slopes.
•
Travel up and down slopes at a 45° angle rather than
across, to prevent unit from tipping over.
Interrupting Operation
•
Before leaving the operator's position:
— Park on level ground.
— Release bail.
— Shut off the engine.
•
Release bail and wait until the blades stop moving:.
— when not using;
— for transport;
— when crossing surfaces other than grass.
•
Stop the engine, release bail and wait until the blade
stops moving:
— before refueling;
— before making blade adjustment.
•
Stop the engine, disengage the master clutch, and
disconnect the spark plug wire(s):
— before clearing blockages;
— before checking, cleaning or working on the ma-
chine;
— after striking a foreign object. Inspect the machine
for damage and make repairs before restarting;
— if the machine begins to vibrate abnormally: shut off
machine immediately. Inspect and make repairs as
needed before restarting;
— except for repairs or adjustments as specifically
noted, such as for carburetor adjustment, where
the engine must be running. Keep hands and feet
clear of moving parts in these circumstances.
•
Allow the blades to come to a complete stop when
stopping operation to clear blockages, unclog, inspect
the machine, do maintenance or repair.
•
Reduce the throttle setting during engine shut-down
and, if the engine is provided with a shut-off valve, turn
the fuel off at the conclusion of operation.
MAINTENANCE SAFETY
In general
•
Maintain machine according to manufacturer's sched-
ule and instructions for maximum safety
and best results.
•
Park machine on level ground.
•
Never allow untrained personnel to service machine.
•
Guards should only be removed by qualified mainte-
nance technician for maintenance/service. Replace
when work is complete.
•
Adjust or repair only after the engine has been
stopped and the blade has stopped moving.
•
Disconnect spark plug wire(s) before doing any main-
tenance.
•
Replace parts if worn, damaged or faulty. For best
results, always replace with parts recommended by
the manufacturer.
•
Do not dismantle the machine without releasing or
restraining forces which may cause parts to move
suddenly.
•
Provide adequate support, e.g. jack stands for lifted
machine or parts if working beneath.
•
Do not put hands or feet near or under
rotating parts.
•
Clean up spilled oil or fuel thoroughly.
•
Replace faulty mufflers.
•
To reduce fire hazards, keep the engine, muffler, and
fuel storage area free of grass, leaves, debris buildup
or grease
.
Blades
The rake/seeder blades are sharp and can cut.
Use extra caution when handling. Remove
obstructions with care. Wrap the blade or
wear gloves.
•
Only replace blade. Never straighten
or weld.
•
Keep other persons away from blades.
•
SAFETY
!
WARNING
5
Advertisement
Table of Contents
