Black Box Data Alarm SW705A Manual page 12

7. Run this cable to the Data Alarm's location and
plug its other end, which must be a DB25 male
connector, into the INPUT port on the Alarm's
rear panel, making sure to tighten the screwlocks.
8. If you haven't already, plug the other cable into the
data-destination device. Run that cable to the Data
Alarm's location and plug its other end into the
OUTPUT port on the Alarm's front panel, again
tightening the screwlocks.
9. Once you've finished connecting the data lines, plug
the alarm device (the one you want to get power if
the Data Alarm detects data traffic) into the outlet
on the Data Alarm's front panel.
10. Now plug the female end of the Data Alarm's power
cord into the power inlet on the Alarm's rear panel.
Plug the male end of the cord into a working AC
outlet. The POWER LED on the Alarm's rear panel
should light up.
11. Move the DISABLE switch on the Data Alarm's
front panel to the ENABLE (left) position.
12. Plug in and turn on the data-source and data-
destination devices. If the alarm device has a
POWER ON/OFF switch, turn it on as well.
This completes your Data Alarm installation. The Alarm
system should be ready for continuous operation.
CHAPTER 3: Installation
9