Silencer 322SS Quick Reference Install Manual

SECURITY SYSTEM with KEYLESS ENTRY
FOR PROFESSIONAL INSTALLATION ONLY!
If you are not proficient in the installation of this product or would like a full version
of the installation manual, please visit our web site @www.magnadyne.com
Valet Sw
LED
Note: Locate the vehicle START wire at the ignition switch.
Cut it and follow the instructions below.
To Vehicle Starter Wire
To Ignition Key Start Wire
Red: +12V Battery Power
Brown: (+) Siren
Black: Ground
White: Parking Light Relay Output
White: Parking Light Relay Power Input
Blue: (-) Negative Door Unlock Output
Green: (-) Negative Door Lock Output
Important Note: The main unit should be
securely anchored to a large wire loom or
stable surface for the shock sensor and the
tilt sensor to operate properly.
Pin Wire Color
1 Open
2 Green (-) Door Pin Input
3 Blue (-) Aux Hood/Trunk Input
4 Violet (+) Door Pin Input
5 Yellow (+) Ignition Switch Input
*Note: Low current outputs such as the 200mA, 300mA and 500mA (-) outputs on this unit
will only activate a relay (not supplied). They normally will not control any circuits in the vehicle
without installing a relay. Check your vehicle requirements before making any connections.
Starter Disable Wires
15A
10A
10 9 8
5 4
Function Pin
None 6
7
8
9
10
Quick Reference Install Guide
(see chart)
7 6
3 2 1
Wire Color
Black/White (-) 200mA Dome Light Control Output*
Brown/Black (-) 300mA Horn Output*
White/Blue (-) 200mA Channel 4 Output*
Red/White (-) 200mA Channel 3 Output*
Orange (-) 500mA Ground When Armed Output*
10 PIN
Function