Table of Contents
Advertisement
Check
Rear panel
Line voltage
settings:
Fuse size
Operating
HP 8510C
system
rmware
HP 8510B (if used)
revision:
HP 8360 series
HP 8510
RF source if HP 8360
system bus
address:
LO source if HP 8360
series
RF source if HP 8340B
or HP 8341B
LO source if HP 8340B
or HP 8341B
Controller
3.5 inch drive
HP-IB bus
addresses:
HP 8510
HP 8360 Series Source Check
Software Revision, Language, and HP-IB Address
4
5
MENU
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
HP-IB MENU
NNNNNNNNNNNNNNNNNNNNNNNNNN
ANALYZER
All manuals and user guides at all-guides.com
Should be:
Set to local line voltage See rear panels of each
Appropriate for line
voltage
C.06.50 or higher
B.05.11 or higher
08 Mar.91 or later
LANG = 001
ADDRESS = 10010
(binary)
LANG = 001
ADDRESS = 10010
(binary)
19 (decimal) address
check
18 (decimal) address
check
700 (decimal)
716 (decimal)
Additional
information
instrument
See rear panels of each
instrument
See the label on the
operating system disk
See the label on the
operating system tape
See HP 8360 series
source check
See HP 8360 series
system bus
See HP 8360 series
source check
See HP 8340/41 source
See HP 8340/41 source
See your disk drive
manual for HP-IB
address switch location
Will be checked after
the system is powered
up
Advertisement
Table of Contents
