BERKSHIRE HATHAWAY MARMON FOODSERVICE TECHNOLOGIES PRINCECASTLE NCG9-E Series Operation Manual

BERKSHIRE HATHAWAY MARMON FOODSERVICE TECHNOLOGIES PRINCECASTLE NCG9-E Series Operation Manual

Advertisement

Quick Links

OPERATION MANUAL
NCG9
NCG8
LIMITED WARRANTY
This product is warranted to be free from defects in material and/or
workmanship for a period of 1 year from date of original installation, not to
exceed 18 months from the date of manufacture.
Any component which proves to be faulty in material and/or workmanship
will be replaced or repaired (at the option of Prince Castle, Inc.) without
cost to the customer for parts and labor. This warranty covers on-location
service (i.e. trip charges and/or mileage). Travel mileage is limited to 100
miles (200 Kilometers) round trip (one trip warranty) from an authorized
service agency or its sub-service agency.
This warranty is subject to the following exceptions/conditions:
• Use of any non-genuine Prince Castle parts voids this warranty.
• All labor shall be performed during regular work hours. Overtime
premium (the incremental amount) will be charged to the customer.
• Damage caused by carelessness, neglect and/or abuse (e.g. dropping,
tampering, or altering parts, equipment damaged in shipment, by fire,
flood or an act of God) is not covered under this warranty.
• All problems due to operation at voltages other than that specified on
equipment nameplates are not covered by this warranty. Conversion to
correct voltage is the customer's responsibility.
• Normal adjustments as outlined in this manual are not covered under
warranty.
• This equipment must be serviced by Prince Castle Authorized Service
Agency or a Prince Castle Service Technician during the warranty period.
• Wearable items such as (springs, Teflon sheets, bearings) are not
Included under warranty.
5 floor, Building 8, No. 300 Dingyuan Road, Songjiang District, Shanghai, China, Zip Code 201616
Tel: +86-021-6040-1728 www.princecastle.com
600-C601 RevB_EN
®

Product Identification

HEATING
DISPLAY
INDICATOR
LIGHT (TOP)
HEATING
INDICATOR LIGHT
(BOTTOM)
SET BUTTON
PRODUCT 1 &
UPPER ARROW
BUTTON
PRODUCT 2 &
LOWER ARROW
BUTTON

TABLE OF CONTENTS

Product Identification ......................................1
Safety Information ...........................................2
Model specification ...........................................2
Installation .......................................................3
Initial Start-Up .................................................4
Seasoning the Cooking Surfaces.....................4
Daily Cleaning...................................................6
Spring adjustment.............................................7
Exploding View.................................................8
Wiring Diagram .............................................. 13
Error code table................................... ......... ...15
Prince Castle LLC (China)
NCG9&8 Series
TEMPERATURE
BUTTON/LOGO
TOP HEATER
ON/OFF
INDICATOR
LIGHT (1-4)
PRODUCT 4
BUTTON
PRODUCT 3 BUTTON
1 / 15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MARMON FOODSERVICE TECHNOLOGIES PRINCECASTLE NCG9-E Series and is the answer not in the manual?

Questions and answers

Summary of Contents for BERKSHIRE HATHAWAY MARMON FOODSERVICE TECHNOLOGIES PRINCECASTLE NCG9-E Series

  • Page 1: Table Of Contents

    ® OPERATION MANUAL NCG9&8 Series Product Identification TEMPERATURE HEATING BUTTON/LOGO DISPLAY TOP HEATER INDICATOR ON/OFF LIGHT (TOP) NCG9 HEATING INDICATOR LIGHT INDICATOR (BOTTOM) LIGHT (1-4) SET BUTTON PRODUCT 4 BUTTON PRODUCT 1 & UPPER ARROW BUTTON PRODUCT 2 & PRODUCT 3 BUTTON LOWER ARROW NCG8 BUTTON...
  • Page 2: Safety Information

    ® Safety Information This equipment is intended for commercial occasions and operated by Indicates information important to the proper operation of trained staff. Operation by untrained personnel or those with reduced the unit. Failure to observe may result in damage to the physical, sensory or mental capabilities may result in severe injury or equipment and/or severe bodily injury or death.
  • Page 3: Installation

    ® Installation Installation Before using your new equipment, read and understand all the instructions and labels associated with the unit prior to putting it into operation. Make sure all people associated with its use understand the unit’s operation and safety before they use the unit. 1.
  • Page 4: Initial Start-Up

    ® Initial Start-Up 1. Place unit on table NOTE: The grill may emit a small amount of smoke as the cooking 2. Before using the unit for the first time, wipe surfaces reach 512°F (266°C). Do not be alarmed, as the smoke is down the exterior and toasting area with a damp caused by oils associated with the manufacturing process and will cloth.
  • Page 5: Program Instructions (Electronic Control)

    ® Programming Instructions (Electronic Control) Program Time and Temperature: Switch between °F and °C & Temperature 1. Press any number product button and the LED above Calibration: it will light, then press “SET” button one time and the 1. Press “SET” button one time and the display will display will read "_ _ _ _."...
  • Page 6: Daily Cleaning

    ® Daily Cleaning Never use pumice, griddle stones, or abrasives on DO NOT IMMERSE OR LET THE UNIT STAND IN platen surface. WATER. DO NOT HOSE DOWN THE UNIT. KEEP THE Never strike the griddle surface with a sharp UNIT AWAY FROM RUNNING WATER. instrument or spatula edge.
  • Page 7: Spring Adjustment

    ® Spring Adjustment NOTE: The spring setting which holds the top housing in the up position is set at the factory and should provide many years of use without the need of adjusting After an extended period of time the top housing may not maintain its original setting, therefore the spring tension can be adjusted by loosening and tightening the screws on the back of the unit.
  • Page 8: Exploding View

    ® Exploding View Model: NCG9 Platen Assembly Application Part No. Description 600-309 HANDLE, WELDMENT 76-687 BOLT 5/16-18x1.25 10-C010 BOLT M6X16 600-315 SHOULDER BOLT, LINK 600-310 LINK, LIFT 600-206 BRKT, ARM, TOP FLANGE BEARING ∅ 8MM 600-210 CG-066 NUT,HEX CAP,250-20 76-777 SSCUPSKT 0.3125- 600-211 WELDMENT,HOUSING,TO...
  • Page 9 ® Model: NCG9 Base Assembly Item Part No. Description Application 197-232 FOOT, MOUNTING 600-413 PANEL, FRONT 600-C156 PANEL, FRONT Mechanical Version 600-405 GREASE TRAY 78-233 SWITCH,ROCKER,DPST,IP65,16A 542-164 GUARD,SWITCH 600-C303 OVERLAY, DISPLAY 600-407 PLATE, OVERLAY 600-C302 MAIN PCB 600-C194 PLATE, RALAY 65-058 RELAY PM-096...
  • Page 10 ® Model: NCG8 Platen Assembly Item Part No. Description Application 600-C186 HANDLE, WELDMENT 76-687 BOLT 5/16-18x1.25 10-C010 BOLT M6X16 600-315 SHOULDER BOLT, LINK 600-C181 MOUNT, RUBBER 600-C401 RUBBER,BUFFER 600-C177 LINK, LIFT 600-C178 BRKT, ARM, TOP 600-210 FLANGE BEARING ∅ 8MM CG-066 NUT,HEX CAP,250-20 76-777...
  • Page 11 ® Model: NCG8 Base Assembly Item Part No. Desription Application 197-232 FOOT, MOUNTING 600-C191 WELDMENT,PANEL, FACE 600-C195 WMT, GREASE TRAY 78-233 SWITCH,ROCKER,DPST,IP65,16A 542-164 GUARD,SWITCH 600-C303 OVERLAY, DISPLAY 600-407 BACKER, DISPLAY 600-C302 MAIN PCB 600-C194 PLATE, RALAY 65-058 RELAY PM-096 TRANSFORMER 220V PM-042 TRANSFORMER...
  • Page 12 ® Model: NCG9&8 Teflon sheet kit (optional): Item Part No. Description Application 600-C103 HOOK 600-C104 HOLDER 600-C107 BRACKET 600-C114 TOP CLAMP NCG9 600-C101 TOP CLAMP NCG8 600-C404 TEFLON SHEET, BLACK 390*300 NCG9 600-C406 TEFLON SHEET, BLACK 430*365 NCG8 600-C403 TEFLON SHEET, BROWN 350*238 NCG9 600-C405 TEFLON SHEET, BROWN 470*211...
  • Page 13: Wiring Diagram

    ® Wiring Diagram Electronical Control Version 600-C601 RevB_EN 13 / 15...
  • Page 14 ® Mechanical Control Version 600-C601 RevB_EN 14 / 15...
  • Page 15: Error Code Table

    ® Error Code Table Error Code Criteria Action The set temperature of the top heating plate is not Check top heater and top Heater reached within 20 minutes. relay The temperature of the top heating plate exceeds 315 Check top heater and top Heater degrees relay The set temperature of the bottom heating plate is not...

Table of Contents