Advertisement
1. Components
Freezer Door
Ice Tray
Sliding Case
Temperature Control
(see page 5)
LED Light
(see page 9)
Shelf
(refrigerator compartment)
Minus Ion
(see page 7)
Drain Pan
Vegetable Case
Stand
This illustration shows series models MR-18PA
2. Installation
Install on a completely flat and rigid surface.
Level the refrigerator by rotating the levelling leg located in the front of the right corner.
The refrigerator is then solidly positioned.
Leave a 3-cm space between the sides of the refrigerator.
Leave a 30-cm space between the top of the refrigerator and the ceiling.
Leave a 10-cm space between the back of the refrigerator.
Choose a location which is not exposed to the sun, which is relatively free from dust, heat and humidity,
and which offers good ventilation. This is to guarantee that the heat radiation will not be impaired.
Use in hot spring areas
Corrosion control treatment may be required for the refrigerant circuit (pipe) due to generation of corrosive gases.
Contact the retail store where you purchased the refrigerator.
Warning
Do not block the area in the vicinity of the refrigerator.
If refrigerant leaks, it may accumulate and catch fire or explode.
Do not damage the refrigerant circuit (pipes) or drive screws into it.
Although R600a refrigerants are combustible, the refrigerant circuit is hermetically sealed and normally leaks will not occur.
Warning
In case the refrigerant circuit is damaged, do not use any electric appliances
or fire equipment nearby, and open all windows to provide good ventilation.
Please also contact your local maintenance agent to follow up.
4
Door Switch
Egg Rack
Free Pocket
Adjustable Pocket
Bottle Pocket
Door Gaskets
Door
Advertisement
