1 Overview The cabinet is fitted with a Dixell XR77CH electronic controller, which is pre-programmed. SKOPE does not recommend changing the settings unless it is absolutely necessary. To ensure efficient operation, the controller automatically forces a defrost cycle when required.
Down button: To view the lowest temperature recorded inside the cabinet (since the last controller reset). On/Off button: Function disabled. Contact SKOPE to enable. Defrost cycle indicator: On during defrost cycles. Flashes during drip time (e.g. after a defrost cycle).
The cabinet temperature setpoint is set at the factory and can be adjusted if necessary. Setpoint SKOPE does not recommend changing the setpoint unless it is absolutely necessary, and then only by small increments at a time. Procedure 5: To view the temperature setpoint 1.
On/Off When the on/off function is enabled, the cabinet can be switched off and on by pressing and holding the On/Off button on the controller faceplate for 1 second. Contact a SKOPE service Function agent if this function is required.
SKOPE SKT-NZ and SKFT-NZ Series 4 Alarms The following table explains messages that the electronic controller displays and related alarms. Alarms signal unexpected operational changes in the cabinet and stop when action is taken to resolve the problem. Note that cabinets with twin refrigeration cartridges have two electronic controllers, and an alarm might be coming from the unseen controller.
Need help?
Do you have a question about the SKT-NZ Series and is the answer not in the manual?
Questions and answers