HoMedics MyChill - Personal Space Cooler Quick Start Guide

PERSONAL SPACE COOLER LOCATION

Before filling the unit with water, unplug the Power Adapter from the wall and from the unit.

NOTE:
Always use two hands to carry the unit.

Place the Personal Space Cooler in the desired location prior to filling with water. Please see your instructon manual for recommended distances. We recommend placing a waterproof pad under the unit.

1. Be sure the cooling cartridge is positioned with the "V-shaped" vents facing upward. Never operate the unit without the cooling cartridge.
2. Remove the water tank and turn the tank upside down – remove the tank cap by turning it counter-clockwise.
3. Fill the water tank with clean, cool (not cold) water. We recommend using distilled water if you live in a hard water area. Never use any additive or place essential oils into the water. Even a few drops will damage the unit.
4. Replace the tank cap by turning clockwise until tight. Do not overtighten.
5. Place the tank into the MyChill cavity, making sure the tank is firmly seated. Water will begin to transfer into the water reservoir.
6. Once the water stops emptying into the water reservoir, remove the water tank and refill following steps 2-5 to fully fill the water tank and reservoir.
7. Adjust the front vents up or down to direct the airflow as desired.
8. Your personal space cooler is ready for use.

Plug the power adapter into the back of the unit and the other end into a household electrical outlet. Press the power button to turn the unit on.