Table of Contents
Advertisement
Open Circuit Voltage
If the load indicates poor battery condition, allow the battery to stabilize for a
few minutes and check the open circuit voltage by voltmeter:
a. Battery is considered charged if it measures
75% or more. If it failed the load test
with 75% charge, replace battery.
User-Maintenance Instructions
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Do not use damaged equipment. If abnormal noise or vibration,
occurs, have the problem corrected before further use.
Inspection, Maintenance, and Cleaning
Note: These procedures are in addition to the
regular checks and maintenance explained as part
of the regular operation of the air-operated tool.
1. Periodically check all nuts, bolts,
and screws for tightness.
2. Store in a clean, dry location.
Record Product's Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Replacement parts are not available for this item. Reference UPC 193175451699.
Item 58944
Open Circuit Voltage
11.7V or Lower
12.0V
12.2V
12.4V
12.6V or Higher
For technical questions, please call 1-888-866-5797.
b. If Battery charge measures less than 75%,
it should be charged and load tested again.
Replace battery if it fails again. The values
in the following table are for a 12V battery;
divide values in half for a 6V battery.
% of Charge
0%
25%
50%
75%
100%
3. Clean the outside of the unit with a damp cloth.
Never use solvents to clean any parts of this tool.
Allow tool to dry completely before use.
4. Use compressed air to blow out
debris from the load vents.
5. After each use, clean the Cable Clamps of
any possible battery electrolyte. Apply a thin
coat of silicon grease to prevent corrosion.
Page 7
Advertisement
Table of Contents
