Related Manuals for Allmatic B.RO MINI 1CH
Summary of Contents for Allmatic B.RO MINI 1CH
- Page 1 B.RO MINI 1CH Programmable radio receiver, single relay output. 6-1620051 - English - rev.8 - 30/09/2021 - FW:BRO50AM...
- Page 2 INDEX 1. GENERAL SAFETY WARNINGS 2. DESCRIPTION AND TECHNICAL CHARACTERISTICS 3. FIRST INSTALLATION 4. LEARNING OF A TRANSMITTER 5. RELAY OUTPUT PROGRAMMING 6. LEARNING A NEW TRANSMITTER THROUGH A LEARNED ONE 7. CANCELLATION OF A LEARNED SINGLE TRANSMITTER 8. TOTAL RESET OF THE DEVICE 9.
- Page 3 The B.RO MINI 1CH is a miniaturized Rolling Code receiver programmable with single voltage-free contact relay output, already equipped with 30 cm long cables. In the B.RO MINI 1CH it is possible to configure the relay output in 3 different modes of use: "toggle"...
- Page 4 4. LEARNING OF A TRANSMITTER The B.RO MINI 1CH is compatible with all Rolling Code Allmatic transmitters. Before learning a new remote control make sure that the type of transmitted code is compatible with that of the receiver in use and move close to the receiver itself.
- Page 5 5. RELAY OUTPUT PROGRAMMING The receiver has three modes in which you can program the operation of the relay output (Normally Open Contact). In TOGGLE mode, the relay changes its status each time the transmitter button is pressed. In IMMEDIATE mode, the relay output remains closed until the transmitter button is pressed. In TIMED mode, from the moment the transmitter button is pressed, the relay output remains closed for a programmable time of 1 to 120 seconds.
- Page 6 6. LEARNING A NEW TRANSMITTER THROUGH A LEARNED ONE The ability to learn a new remote using one already learned is linked to the type of transmitter in use. If the transmitter is not compatible with this procedure, please refer to Chapter 4 of this manual to learn a new remote control. Make sure the receiver is powered and ready to use (LED off).
- Page 7 8. TOTAL RESET OF THE DEVICE WARNING! Performing the reset procedure results in the deletion of all previous remote controls learned in the receiver. This procedure allows to completely erase the radio memory of the receiver and to return the receiver to its default mode of use (IMMEDIATE mode of use).
- Page 8 ALLMATIC S.r.l 32026 Borgo Valbelluna – Belluno – Italy Via dell’Artigiano, n°1 – Z.A. Tel. 0437 751175 – 751163 r.a. Fax 0437 751065 www.allmatic.com - E-mail: info@allmatic.com...
Need help?
Do you have a question about the B.RO MINI 1CH and is the answer not in the manual?
Questions and answers