U-Line H-7589 Assembly page 2

Figure 2
2
5
Figure 3
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
1
3
4
2. Align armrest with holes on bottom of seat cushion.
Use two 1/4 x 1¾" screws (2) and one 1/4 x 1½" screw
(1) with three washers (5) to attach. Repeat on
opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism over pre-drilled holes on underside
of seat cushion. Attach mechanism to seat cushion
using four 5/16 x 1" screws (3) and Allen wrench.
(See Figure 3)
4. Align back cushion mounting plate with holes on
bottom of seat cushion. Use four 5/16 x 1½" screws (4)
and Allen wrench to attach. (See Figure 4)
0921 IH-7589