Table of Contents
Advertisement
en Cleaning and servicing
Dis-
Selection
play
Time for selecting hotplates
– Unlimited: The last hotplate selected can
always be adjusted without having to select it
1
again.
– You can adjust the last hotplate selected
within 10 seconds after selecting it. After this
time you have to select the hotplate again be-
fore adjusting it.
Resetting to the factory settings
– Switched off.
– Switched on.
Factory setting
1
12.2 Changing basic settings
Requirement: The hob is switched off.
Switch on the hob.
1.
Within the next 10 seconds press and hold
2.
approx. 4 seconds.
and flash alternately on the left-hand display.
a
lights up on the right-hand display.
a
13 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
13.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Never use unsuitable cleaning products.
▶
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
12
1
Repeatedly touch
3.
pears on the left-hand display.
Set the required value on the control panel.
4.
Press and hold
5.
a The setting is activated.
Tip: To exit the basic settings without saving, switch off
the hob using
for
13.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note: Note the information on unsuitable cleaning
products. → Page 12
Requirement: The hob has cooled down.
Remove heavy soiling using a glass scraper.
1.
Clean the hob with a cleaning product for glass
2.
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip: You can achieve good cleaning results using a
special sponge for glass ceramic.
13.3 Cleaning the hob surround
Clean the hob frame after use if dirty or stained.
Notes
¡ Note the information on unsuitable cleaning
products. → Page 12
¡ Do not use the glass scraper.
until the required indicator ap-
for 4 seconds.
. Switch the hob on again and reset.
Advertisement
Table of Contents
