Related Manuals for KNOP PU901
Summary of Contents for KNOP PU901
- Page 1 User manual PU901 © KNOP Elektronik A/S Fabriksvej 20DK-7600 Struerknop@knop.dkknop.dk+45 97840444...
-
Page 2: Table Of Contents
Warnings and safety instructions Intended use Testing and commissioning Check the coverage area Location Service Battery alarm Changing the battery Main menu Cleaning Spare parts and accessories Technical data Explanation of symbols and approvals © KNOP Elektronik A/S Fabriksvej 20DK-7600 Struerknop@knop.dkknop.dk+45 97840444... -
Page 3: Warnings And Safety Instructions
● Keep new and used batteries away from children. ● If the battery compartment cannot be closed properly, discard the product and keep it away from children. ● Read the intended use before using. © KNOP Elektronik A/S Fabriksvej 20DK-7600 Struerknop@knop.dkknop.dk+45 97840444... -
Page 4: Intended Use
The product is designed to activate a KNOP 900 series wireless receiver when a user presses the button. PU901 can be used when the user cannot activate an alarm with a pull cord or push button. PU901 must be coded into the receiver and the receiver must be switched on for the system to work. -
Page 5: Location
The push contact can be mounted on e.g. a gooseneck, contact your retailer for more information. Service When the user blows hard enough on the propeller to activate PU901, it will flash a green light. The receiver will give an acknowledgement, after which PU901 will glow steady green, indicating that the transmission was successful. -
Page 6: Cleaning
The product is then thoroughly tested. If necessary, the propeller can be replaced with a new one. See section "Accessories". Spare parts and accessories Spare parts and accessories can be ordered from Knop Elektronik A/S at www.knop.dk. © KNOP Elektronik A/S... -
Page 7: Technical Data
The right to make changes is reserved. All rights reserved. © KNOP Elektronik A/S Measured outdoors with unobstructed view between transmitter and receiver. In buildings the range is reduced. Expected battery life depends on usage and battery brand. © KNOP Elektronik A/S Fabriksvej 20DK-7600 Struerknop@knop.dkknop.dk+45 97840444... -
Page 8: Explanation Of Symbols And Approvals
The product must not be used if the packaging is damaged. Medical Device Class 1 Manufacturer KNOP Elektronik A/S, Fabriksvej 20, DK-7600 Struer, Denmark Read the manual(s) before installation and commissioning. Interference may occur in an environment with equipment marked with this symbol. Must be protected against liquids.