Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Nordic POBA2100
Summary of Contents for Nordic POBA2100
- Page 1 18V CORDLESS IMPACT DRIVER OPERATING MANUAL...
- Page 2 NORDIC PRODUCT SPECIFICATION Voltage: No load speed: 0-2600rpm Impact Frequency: 0-3400tpm Max Torque: 110N.m Chuck Capacity: 1/4” GENERAL POWER TOOL SAFETY WARNINGS Read all safety warnings and instructions. Failure to heed warnings and follow instructions may result in electric shock, fire and/or serious injury.
- Page 3 NORDIC 2.3 PERSONAL SAFETY • Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool when you are tired or under the influence of drugs, alcohol or medication. A moment of inattention when operating a power tool may result in serious personal injury.
- Page 4 NORDIC 2.5 SERVICE Your power tool should be serviced by a qualified specialist using only standard spare parts. This will ensure that it meets the required safety standards. Special safety instructions for impact drivers • Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring.
- Page 5 NORDIC • In case of skin or eye contact, follow the instructions below: 1. Immediately rinse with water. Neutralize with a mild acid such as lemon juice or vinegar. 2. In case of eye contact, rinse abundantly with clean water for at least 10 minutes.
- Page 6 NORDIC Ambient temperature 40°C max. (only for battery) Do not expose charger and battery pack to water Use battery and charger only in closed rooms Do not incinerate battery pack or charger 6. BEFORE YOU START The tool is equipped with a tool/battery protection system. This system automatically cuts off power to the motor to extend tool and battery life.
- Page 7 NORDIC LIGHTING UP THE FRONT LAMP Pull the switch trigger to light up the lamp. The lamp keeps on lighting while the switch trigger is being pulled. The lamp goes out approximately 10 seconds after releasing the switch trigger. NOTE: When the tool is overheated, the tool stops automatically and the lamp starts flashing. In this case, release the switch trigger.
- Page 8 NORDIC The fastening torque is affected by a wide variety of factors including the following. After fastening, always check the torque with a torque wrench. When the battery cartridge is discharged almost completely, voltage will drop and the fastening torque will be reduced.
Need help?
Do you have a question about the POBA2100 and is the answer not in the manual?
Questions and answers