Advertisement
Instructions for Ultraweld
Grounding Connections
®
Stud to Rail
RMVHBS
Place stud in mold so end to be welded is 1/8" from rail surface. If this is not
possible due to using a short stud, cut end of stud to a 25° angle. Position as
shown.
NOTE: All 3/4"and 1" studs must be cut at the 25° angle.
7.19.19
Instruction Sheet RMVHBS
Advertisement
Table of Contents
Related Manuals for Harger ULTRAWELD RMVHBS
Summary of Contents for Harger ULTRAWELD RMVHBS
- Page 1 Instructions for Ultraweld Grounding Connections ® Stud to Rail RMVHBS Place stud in mold so end to be welded is 1/8” from rail surface. If this is not possible due to using a short stud, cut end of stud to a 25° angle. Position as shown.
- Page 2 GENERAL SAFETY INSTRUCTIONS positioning of conductors into mold. Lock mold with 1. Always wear proper clothing, safety glasses and gloves when handle clamps or frame, which ever is the case. exothermic welding. 5. Insert steel disk being sure it is directly centered over the 2.
Need help?
Do you have a question about the ULTRAWELD RMVHBS and is the answer not in the manual?
Questions and answers