Advertisement
Quick Links
Thank you for picking us over the competition. For years we have been a leading provider of PoE over cat5
and Power Fiber System. Please take a few minutes to read through this guide before you get started. Not
only there are some helpful tips, but also we have some guides to help you plan and install your switch.
Installation Requirements
If this product is for indoor application, pick the cat5e (or higher category) UTP cable. We recommend you choose
pure copper UTP cable. Pure copper not only can guarantee a maximum transmission distance, but also the
bandwidth.
NOTE: Do not expose this switch to a rain or moisture environment which may cause electric shock or fire. The
switch should be installed at places with a good ventilation system
Hardware Overview
Front Panel
Port
Description
1-16
10/100/1000 SFP slot.
17-24
RJ45 port - 10/100/1000 Ethernet
25-26
10/100/1000 SFP slot
Console
CLI connection – Baud Rate : 9600
Reset
Reset button the switch.
PWR
OFF: No power Green: Power ON
Data
OFF-No Link
(Link/ACT)
Red-10/100/1000mbps link flashing indicates data exchanging.
PWR
OFF: No power Green: Power ON
L2+ Managed switch
Advertisement
Summary of Contents for Fastcabling L2+
- Page 1 L2+ Managed switch Thank you for picking us over the competition. For years we have been a leading provider of PoE over cat5 and Power Fiber System. Please take a few minutes to read through this guide before you get started. Not only there are some helpful tips, but also we have some guides to help you plan and install your switch.
- Page 2 Detail Description Ground ESD grounding for ESD protection. The screws and washer are included. Power Connect to AC power cord. 100V-240VCA 50/60Ghz. Hardware Installation Place the Managed switch on the flat, horizontal surface or mount it on the wall. Install the Switch on a desktop, please attach these cushioning rubber feet provided on the bottom at each corner of the Switch in case of external vibration.
- Page 3 3. Now connect the fiber optic cable to the SFP module, then connect the other end of the fiber optic cable to your another IP device. Log Into web browser The default IP address is 192.168.2.1/24. You can log into the web browser to configure the switch. Depress the reset button at the front and hold it for 10 seconds, then release can set back the switch to 192.168.2.1.
- Page 4 Visit our help site fastcabling.com/support Declaration of Conformity We. Fastcabling LTD., hereby declare that the products: Fastcabling L2+ Managed Switch is in conformity with all the essential requirements of EMC Directive 2014/30/EU Assessment of compliance of the product with the requirements relating to the following specifications:...