Insert the pump cap and screw it
5.
on as far as it will go.
90°
The handle on the pump cap must
be in a vertical position.
Insert the maintenance flap and
6.
lock it into place.
1
Close the maintenance flap.
7.
18.6 Cleaning the intake
opening in the rubber
gasket
Regularly check the intake opening
in the rubber gasket for any block-
ages and clean the intake opening.
Open the door.
1.
2
Cleaning and servicing en
Check the intake opening for
2.
blockages and remove any block-
ages.
Note: Do not use any sharp or poin-
ted objects.
18.7 Cleaning the water outlet
hose at the siphon
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
55