Advertisement
terminal and the cable from the left speaker to the left terminal.
1. Strip off the outer covering, and twist the center conductor. Make
sure the bare ends of the wires are not unravelled. (If they are,
twist them tight again.)
2. Insert the wire to the rear panel of the unit and close the lever.
Notes :
- To prevent damage to circuitry, never short-circuit positive (+) and
negative (-) speaker wires.
- Be sure to connect only positive (red) wires to positive (+)
terminals and negative (black) wires to negative (-) terminals.
Placement
Place the speaker so that the super tweeter is on the outside.
Notes :
- You cannot take the front net off the speakers.
Connection
Use only the supplied speakers.
- Using other speakers can damage the unit and sound quality will
be negatively affected.
- Set the speakers up on an even surface to prevent them from
falling. Take proper precautions to prevent the speakers from
falling if you cannot set them up on an even surface.
Positioning for best effect.
How you set up your speakers can affect the bass and the sound field. Note the following points.
PDF created with pdfFactory Pro trial version
3
www.pdffactory.com
Advertisement
