Advertisement

Contact number: 0861 50 35 50
AQUAHEAT HEAT PUMP
OPERATING MANUAL
TF200/3
PC8001 Controller
Ref: 01
Page 1 of 11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TF200/3 and is the answer not in the manual?

Questions and answers

Summary of Contents for AQUAHEAT TF200/3

  • Page 1 Contact number: 0861 50 35 50 AQUAHEAT HEAT PUMP OPERATING MANUAL TF200/3 PC8001 Controller Ref: 01 Page 1 of 11...
  • Page 2: Usage And Operation

    USAGE AND OPERATION 1. Function of wire controller Button Name Function Press this button to start/shut off the unit, cancel current operation or ON / OFF back to upper interface HELP Press this button to check button function or system state Press this button to change the current mode, page up or confirm MODE current operation, enter or save...
  • Page 3 2. Usage of wire controller 2.1 To set temperature Press (2 seconds) to turn unit off Press to set the temperature, press to require temperature Press to set Press (2 seconds) to turn unit on 2.2 To enter system Press twice TEMPERATURE: Press to enter, press...
  • Page 4: Parameter Set

    3. Usage of wire controller TO ENTER PARAMETER SETTING INTERFACE: Turn unit off Press and hold until password shows, press to 66 and press to enter Display shows: PARAMETER SET; /. Hardware: /01. System 1 HP /17. Coil 4 probe /02.
  • Page 5 A. Protection: A 01. HP delay 10 seconds A 05. Deice diff A 02. LP delay 300 seconds A 06. setting 13.0 A 03. Comp. limit - 15.0 A 07. Spray se 35.0 A 04. Deice temp C. Compressor: C 01. Min. on time 120 seconds C 04.
  • Page 6 E. Elc Expansion valve: E 01. EEV 1 mode Auto E 09. Init. place 3 350N E 02. Super heat 1 E 10. EEV 4 mode Auto E 03. Init. place 1 350N E 11. Super heat 4 E 04. EEV 2 mode Auto E 12.
  • Page 7 H 02. Num. system H 08. Coil use Deice H 03. 4V logic H-On H 09. Address H 04. 4V order Advance H 10. Baud rate 9600 H 05. Mode type Heat PUPP H 11. Parity H 06. Type Swimming H 12.
  • Page 8: Manual Control

    MANUAL CONTROL; ALARM RECORDS; Compressor 1 Example of error: Compressor 2 1. E03 28/06/2013 14:00 Compressor 3 Compressor 4 Fan high speed Fan low speed Circulate pump 4-way Valve Elec. Heater Spray valve Alarm PARAMETER RESET; TEMP. TYPE; Reset the settings to factory default values Celsius degree Press to confirm...
  • Page 9 Ref: 01 Page 9 of 11...
  • Page 10 Sample images Ref: 01 Page 10 of 11...
  • Page 11 Ref: 01 Page 11 of 11...

Table of Contents