Table of Contents
Advertisement
8 Disassembly and Assembly Instructions
8.1.
Remove the Rear cover
1. See PCB Layout (Section 3)
8.2.
Remove the AC inlet
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the connector (P9).
3. Remove the screws (×2
4. Remove the screw (×1
8.3.
Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable
2. Disconnect the connectors (P2, P6, P11, P34 and P35).
3. Remove the screws (×5
) and remove the Inlet metal.
) and remove the AC inlet.
) and remove the P-Board.
8.4.
Remove the Terminal covers
and the shield metals
1. Remove the claw (×1
2. Remove the Side terminal cover.
3. Remove the claw (×1
4. Remove the Bottom terminal cover.
5. Remove the screw (×1
6. Remove the USB terminal cover and USB shield metal.
7. Remove the screws (×2
8. Remove the Bottom shield metal.
9. Remove the screw (×1
10. Remove the Side shield metal.
22
).
).
).
).
).
Advertisement
Table of Contents
