Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Accton Technology EM4601-SX-SC
Summary of Contents for Accton Technology EM4601-SX-SC
- Page 1 1000BASE-SX Gigabit Uplink Module EM4601-SX-SC Quick Installation Guide...
- Page 3 Quick Installation Guide EM4601-SX-SC Gigabit Uplink Module Slide-in module with 1 1000BASE-SX (SC-type) port...
- Page 4 Sales: 800-926-9288 FAX: 886-3-5770-267 Support: 888-398-4101 or 949-707-4847 Internet: support@accton.com.tw RMA: 800-762-4968 FAX: 949-707-2460 Accton is a trademark of Accton Technology Corporation. Other trademarks or brand names mentioned herein are trademarks or registered trademarks of their respective companies. EM4601-SX-SC E062000-R01 150471-102...
-
Page 5: Table Of Contents
Contents Description of Hardware Gigabit Uplink Module Gigabit Port LEDs Installing the Module Package Contents Handling the Modules Instructions Maximum Cable Length Troubleshooting Product Specifications EMI Certification FCC Class A Certification (USA) Canada Department of Communications - Class A BSMI Class A (Taiwan) VCCI Class A Compliance (Japan) CE Mark Declaration of Conformance for EMI and Safety (EEC) Safety Compliance... - Page 6 Contents...
-
Page 7: Description Of Hardware
Description of Hardware Gigabit Uplink Module The EM4601-SX-SC fiber optic module is designed for use in Accton switch models which have a single-port Gigabit Ethernet transceiver slot. At present, suitable units include the CheetahSwitch Workgroup-3628 (ES3628). Detailed information about configuring these modules and advice about Fast Ethernet configuration rules can be found in the switch’s user guide. -
Page 8: Installing The Module
Do not install this module in any unit other than the CheetahSwitch Workgroup-3628 (ES3628). Contact your distributor for advice on newly released switches which may be designed for use with these modules. The EM4601-SX-SC fiber optic module is field installable. Just follow the instructions below. Package Contents This package includes: •... - Page 9 Description of Hardware Keep the original faceplate for future use. If you should remove the module, replace the faceplate to prevent dust and debris from entering the unit and to maintain proper air flow. Insert the new module into the switch: Holding the new module with the text on the front panel upright, carefully slide the module into the lower right slot on the rear panel, and press gently until it snaps into place.
- Page 10 User Guide Secure the new module: Secure the new module in place by screwing the attached screws clockwise into the switch’s chassis. Tighten them enough to secure the module, but not so tight as to prevent them from being unscrewed by hand.
-
Page 11: Maximum Cable Length
Troubleshooting Maximum Cable Length Cable Types and Specifications Connector Cable Type Max. Length RJ-45 10BASE-T Cat. 3, 4, 5 100-ohm UTP 100 m (328 ft) RJ-45 100BASE-TX Cat. 5 100-ohm UTP 100 m (328 ft) 100BASE-FX 50/125 or 62.5/125 micron core multimode fiber SC or ST Half duplex 412 m (1,351 ft.) -
Page 12: Product Specifications
User Guide Product Specifications Access Method CSMA/CD Ports 1 1000BASE-SX Network Interface SC connector: 62.5/125 or 50/125 micron multimode fiber cable Communication Mode Full duplex, auto-negotiation for flow control LED Indicators Link, TX, RX Size 14.8 x 11.2 x 2.1 cm (5.8 x 4.4 x 0.83 in.) Power Consumption 4W maximum Temperature... -
Page 13: Bsmi Class A (Taiwan)
EMI Certification BSMI Class A (Taiwan) VCCI Class A Compliance (Japan) CE Mark Declaration of Conformance for EMI and Safety (EEC) This is to certify that this product complies with ISO/IEC Guide 22 and EN45014. It conforms to the following specifications: EMC: EN55022(1988)/CISPR-22(1985) class A... -
Page 14: Safety Compliance
User Guide Safety Compliance Warning: Fiber Optic Port Safety When using a fiber optic media expansion module, never look at the transmit laser while it is powered on. Also, never look directly at the fiber TX port and fiber cable ends when they are powered on. Avertissment: Ports pour fibres optiques - sécurité... -
Page 15: Warranty
ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY OTHER LIABILITY. Optional Hardware EM3604-FX-SC: Media Module with 4 100BASE-FX (SC-type) Ports EM4601-SX-SC: Media Module with 1 1000BASE-SX (SC-type) Port ST5002: SC to ST Plug Converter for Fiber Optic Module... - Page 16 EM4601-SX-SC E062000-R01 150471-102...