2. Selecting and Using a Tag
A Tag must be docked according to color in the Base Unit for programming!
Each of the three Time Tracker
independently without disruption to in-progress timing for another Tag.
Press a Tag Mode button to toggle through 1 of 3 modes for a specific
Tag timer:
Tag Mode
Buttons
The Base Display will flash to indicate the Tag line being programmed.
The color light corresponding to the Tag on the Base Display will also light up to
indicate the Tag is being programmed.
Mode 1: Countdown with Audio Alarm
00 00
00 00 00 00
COUNT
COUNT
In COUNTDOWN mode, enter a target time in the display screen from which the
Tag will count down to zero (00:00:00). The alarm bell icon
the countdown mode is being programmed for a Tag.
Use the HR, MIN, or SEC buttons to enter the countdown time when prompted
by the flashing 00:00:00.
Remove the Tag from the Base Unit to begin the countdown.
Replacing the Tag in the Base Unit and removing it again will restart the Tag's
programmed countdown.
Return the Tag to the Base Unit and press Stop to reset the Tag to the
previously programmed time.
If Stop is not pressed, the Tag will continue its countdown while docked in the
Base Unit until reaching 00:00:00. The Tag will then reset to its previously
programmed time. No alarm notifications occur for Tags expiring while in the
Base Unit.
Press the HR, MIN, or SEC buttons one time and release to increase time
by increments of one. Press and hold the buttons to quickly scroll through
digits 0–99 (HR) or 0-59 (MIN, SEC). Release the button to stop scrolling.
The maximum COUNTDOWN time is 99:59:59.
Tag will remember its current mode until assigned another mode or time amount,
or until its battery is removed to clear the Tag's memory.
Mode 2: Countdown with No Audio Alarm
This mode operates the same as Mode 1, except that the audio alarm for the Tag
timer is disabled.
Tags can be programmed and removed
®
DOWN
DOWN
00 00
00 00 00 00
COUNT
COUNT
DOWN
DOWN
00 00
00 00 00 00
COUNT
COUNT
UP UP
00 00
00 00 00 00
COUNT
COUNT
DOWN
DOWN
will flash indicating
3
Need help?
Do you have a question about the Time Tracker LER6999 and is the answer not in the manual?