Please keep instructions for future reference.
A
Refrigerator Latch
®
Dreambaby
Refrigerator Latch helps prevent children from opening
fridges or freezers. May also suit other household appliances
(which do not generate heat).
To Install:
1. Locate position to apply Latch, above reach of child.
2. Thoroughly clean and dry surfaces.
3. Remove backing paper from small catch piece, and press firmly
onto door section (A).
4. With the door closed, position the latch so that the pieces will lock
together, with a gap of 0.1in (2mm) between them. Mark the position (B).
5. Remove backing paper from latch and press it firmly onto the
side of appliance.
6. As with all self adhesive products, strong adhesion is achieved by
allowing adhesive to set for several hours. If possible, install in the
evening to allow adhesive to set overnight.
To Use: To open, lift latch clear of catch, and open fridge door (C).
Locks automatically when door is closed.
To Remove Product: Use rubber cement solvent, eucalyptus oil, or similar
type of product. Keep remover out of the reach of children.
To Relocate Product: Replace adhesive tape with 'strong' double sided tape.
Caution: There is no substitute for proper adult supervision.
This product is only a deterrent. Discontinue use when child is able to open it.
Warning: This Latch is not to be used with appliances which generate heat.
Do not use this product on oiled surfaces, as the adhesive will not stick.
®
Look for the Dreambaby
range of Child Safety and Care Products.
TEE-ZED PRODUCTS, LLC ACCEPTS NO RESPONSIBILTY FOR ANY LOSS OR DAMAGE SUFFERED BY ANY PERSON AS A RESULT OF THE USE
OR MISUSE OF THESE GOODS. IN THE CASE OF ANY DEFECT IN THE GOODS, TEE-ZED'S LIABILITY SHALL BE LIMITED SOLELY TO
REPLACEMENT OF THE DEFECTIVE GOODS.
TEE-ZED PRODUCTS, LLC N'ACCEPTE AUCUNE RESPONSABILITÉ POUR LA PERTE OU LES DOMMAGES RÉSULTANT DE L'USAGE OU DU
MÉSUSAGE DE CES PRODUITS. EN CAS DE DÉFAUT DES PRODUITS, LA RESPONSABILITÉ DE TEE-ZED SE LIMITE AU REMPLACEMENT DES
PRODUITS DÉFECTUEUX.
Dreambaby
®
products by
Tee-Zed Products, LLC
Les produits Dreambaby
®
par
PO Box 1662
®
Los productos Dreambaby
por
Jamestown, NC 27282
®
Produtos Dreambaby
por
USA Tel: (336) 454-5716
Toll free: (888) 271-6959
©2013 Tee-Zed Products, LLC
Veuillez conserver les consignes pour future référence.
Z
B
Loquet de réfrigérateur
Le Loquet de réfrigérateur Dreambaby
frigidaire ou le congélateur. Peut également s'adapter à d'autres appareils
électroménagers (ne générant pas de chaleur).
Installation:
1. Déterminez l'emplacement du Loquet sur le réfrigérateur, hors de la
2. Nettoyez et séchez soigneusement les surfaces.
3. Enlevez le papier de protection du petit élément de crochet, et appuyez
4. Avec la porte fermée, positionnez le loquet de sorte que les éléments
5. Enlevez le papier de protection du loquet et appuyez celui-ci fortement
6. Comme pour tous les produits autocollants, une adhésion optimale est
Usage: Pour ouvrir, dégagez le loquet du crochet et ouvrez la porte du
frigidaire. Se verrouille automatiquement lorsque la porte se ferme.
Attention: Il n y a pas de substitut pour une bonne supervision d'adulte.
Ce produit est seulement préventif. Discontinuez son utilisation quand
l'enfant parvient à l'ouvrir.
Avertissement: Ce loquet ne doit pas être utilisé avec un appareil qui produit
de la chaleur. N'employez pas ce produit sur des surfaces huilées, car
l'adhésif ne collera pas.
Recherchez la gamme Dreambaby
TEE-ZED PRODUCTS, LLC NO SE HACE RESPONSABLE DE NINGUNA PÉRDIDA O DAÑO SUFRIDO POR ALGUNA PERSONA COMO RESULTADO
DEL USO O DE LA MALA UTILIZACIÓN DE ESTAS MERCANCÍAS. EN CASO DE CUALQUIER DEFECTO EN LAS MERCANCÍAS, LA
RESPONSABILIDAD DE TEE-ZED'S SERÁ LIMITADA ÚNICAMENTE AL REEMPLAZO DE LAS MERCANCÍAS DEFECTUOSAS.
A EMPRESA TEE-ZED PRODUCTS, LLC NÃO SE RESPONSABILIZA POR QUAISQUER PERDAS OU DANOS A QUALQUER PESSOA QUE VENHA A
SOFRER COM O USO CORRETO OU INCORRETO DESTES PRODUTOS. CASO OS PRODUTOS APRESENTAM QUALQUER DEFEITO, A
RESPONSABILIDADE DA EMPRESA TEE-ZED ESTÁ APENAS LIMITADA À SUBSTITUIÇÃO DOS MESMOS. VALIDADE INDETERMINADA
Made in China.
Fabriqué en Chine.
Hecho en China.
Fabricado na China.
Z
Gap
Ecartement
portée d'un enfant.
fortement sur la section de la porte (A).
se verrouillent l'un dans l'autre, avec un écartement de 2mm (0,1in).
Marquez l'emplacement (B).
sur le côté de l'appareil.
obtenue en laissant l'adhésif «prendre» pendant plusieurs heures.
Si possible, installez le loquet le soir pour laisser l'adhésif «prendre»
pendant la nuit.
®
de produits de sécurité et de soins pour enfants.
C
®
empêche les enfants d'ouvrir le
L.LC.LS121/1002
info@tee-zed.com
www.dream-baby.com
facebook.com/Dreambabysafety
Need help?
Do you have a question about the Dreambaby and is the answer not in the manual?
Questions and answers