YISEELE YX-700 User Manual page 14

Alarm
indicator
Arm/disarm
notifications
Detector
event
notifications
Entry delay
Ticking and
voice
prompts
Alarm
sound
volume
Factory reset
Hub language
Virtual
password
Turn on/off the alarm light on the panel of the
HUB. After it is turned on, when the alarm system
sounds an alarm, the red indicator light on the
panel of the HUB will flash.
Turn on/off push messages for arming/disarming
the alarm system. After closing, there will be no
APP push message for the arming and disarming
of the alarm system, but the HUB of the alarm
system will have voice prompts for
arming/disarming.
Turn on/off the push messages of all Detectors.
After turning off, the Detector will be triggered
and there will be no APP push messages, but the
HUB of the alarm system will have an alarm
sound.
After the detector is triggered, the system starts
to count down. During the countdown, the HUB
will not sound an alarm; when the countdown is
completed, the siren starts to sound an alarm.
Turn on/off the voice and countdown sound of
the alarm system. When it turned off, the alarm
system will not emit any sound (except for the
alarm sound).
Set the volume of the alarm sound: You can set
three levels: High, Low, Mute. When set to Mute,
there will be no alarm sound.
Restore factory settings: All detectors and
remote controls will be deleted.
The voice switch of the alarm system can switch
different national languages according to
different countries. Support 11 languages.
Only used for Google Home; when the alarm
system is disarmed, Google Home will ask for
this password.