Table of Contents
Advertisement
Chapter 2: Installation
2.1
Gate Installation
2.1.1
Open a hole with a diameter of 35mm on the fate, and the
recommended position is 1/3 to ¼ from the entrance end;
2.1.2
Insert the equipment mounting bracket into the opening of the gate
and fix the equipment nut from the inside of the gate;
2.1.3
Adjust the device to a suitable angle, between 5
2.1.4
Ensure to connect the device using Ethernet cable at the RJ45 Network
Interface before power on.
o
– 15
o
vertical.
Page 4 of 10
Advertisement
Table of Contents
