Sena RC4 Manual
Also See for RC4:

Advertisement

Sena RC4 Manual

Introduction

Introduction

Getting Started

Getting Started

Remove the plastic tape from the battery slot to begin using the RC4.

Installation

Installation

NOTE:
If your handlebar requires better grip for holding the RC4 in place, apply the rubber band around the handlebar.

Replacing the Battery

Replacing the Battery Step 1

Replacing the Battery Step 2

Replacing the Battery Step 3

Button Operation

Tapping
Double Tapping
Press for 1 sec

Power On/Off

Power On
Power On

Deep Sleep
Deep Sleep

Battery Check

Battery Check Step 1

Battery Check Step 2

Bluetooth Pairing

Bluetooth Pairing Step 1

Bluetooth Pairing Step 2

NOTE:

  • You can control the headset using the RC4 only after you pair them together.
  • The RC4 supports Sena headsets with Bluetooth 4.1 or higher.

Factory Reset

Factory Reset

Headset Control

To control your headset using the RC4, please refer to the Quick Reference Guide for button operations on functions such as phone, music, and intercom.

NOTE:
The Multifunction Button remotely controls special buttons such as the Ambient Mode Button of the 20S and the Camera Button of the 10C. Please refer to the Quick Reference Guide for more details.

RC4 Remote Control Operation for Headset

Type Operation Button Command
Basic
Operation
Volume adjustment Tap the (+) Button or the (-) Button
Configuration menu Press the Center Button for 10 seconds

Mobile Phone

Answer phone call Tap the Center Button
End phone call Press the Center Button for 2 seconds
Voice dial Press the Center Button for 3 seconds
Speed dial Press the (+) Button for 3 seconds
Reject incoming call Press the Center Button for 2 seconds
Intercom

Intercom pairing Press the Center Button for 5 seconds
Tap the Center Button of any one of the two Remotes
Start/end each intercom Tap the Center Button
Start Group Intercom Tap the (+) Button and the (-) Button
End all intercoms Press the Center Button for 1 second
Music Play/pause Bluetooth music Press the Center Button for 1 second
Track forward/ back Press the (+) Button or the (-) Button for 1 second
FM Radio

FM radio on/off Press the (-) Button for 1 second
Select preset Press the Center Button for 1 second
Seek stations Double tap the (+) Button or the (-) Button
Scan up FM band Press the (+) Button for 1 second
Stop scanning Press the (+) Button for 1 second
Save preset while scanning Tap the Center Button

RC4 Multifunction Button Operation for Headset

Product Operation Button Command

20S
Ambient Mode Double tap the Multifunction Button
Voice command Tap the Multifunction Button
Start Group Intercom Press the Multifunction Button for 1 second





10C


Camera on Tap the Multifunction Button
Camera off Tap the Multifunction Button and the (-) Button
Start/stop video recording Press the Multifunction Button for 1 second
Take photo Tap the Multifunction Button
Enter Video Tagging mode Press the Multifunction Button for 3 seconds
Start Video Tagging Press the Multifunction Button for 1 second
Exit Video Tagging mode Press the Multifunction Button for 3 seconds
Enter camera configuration menu Press the Multifunction Button for 8 seconds
Exit camera configuration menu Tap the Multifunction Button
Tufftalk Ambient Mode Double tap the Multifunction Button
Start Group Intercom Press the Multifunction Button for 1 second
Others Start Group Intercom Press the Multifunction Button for 1 second

Sena Technologies, Inc.
www.sena.com

Customer Support: support.sena.com
E-mail: support@sena.com

Videos

Sena RC4 Remote Control - Easy Install and Review Video

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Sena RC4 Manual

Advertisement

Need help?

Need help?

Do you have a question about the RC4 and is the answer not in the manual?

Questions and answers

Table of Contents