Table of Contents
Advertisement
C o m m o n f a u l t s a n d t r o u b l e s h o o t i n g
Common faults
Reason
Fault code
Water temperature
Make sure there is cold water, after power off and
E1/E2
sensor abnormal
restart, if still cannot be used normally, please contact
the seller for repair
Fault code HH
Add hot water tem-
Add cold water, the water temperature is reduced to
perature over 53 ° C,
53 ° C, and the protection can eliminate
anti-high temperature
burns protection start
No power
Power plug is not
Plug the power plug according to the correct method
inserted
No heating
Not boot, display "OFF"
Power on, press the "Start" button, "OFF" display
eliminates
No power
Plug the power plug according to the correct method
and start the machine
Not working or
Timing time to the
restart the machine
stopped
automatic shutdown
working
Abnormal protection
Make sure there is cold water, after power off and
halfway
shutdown (such as anti-
restart, if still cannot be used normally, please contact
wire, anti-dry burning,
the seller for repair
sensor abnormalities,
etc.)
Elimination method
08
Scale
Water is heavy or dirty
Special statement
This product has undergone a strict water test before leaving the factory, and a small amount of
water beads may remain in the product, which is normal and does not affect the quality of this
product, please use it with confidence. The drainage system design of this product can basically
exclude the residual water in the internal pipeline of the machine at the lowest point of the water
level. However, it is recommended to flush the inside of the cylinder with clean water after use to
prevent the breeding of bacteria.
P r e c a u t i o n s
If you need to add solid drugs in the bath, please wrap the drugs with gauze and
put them in the medicine box for use, so as not to block the filter screen and the
internal pipeline of the machine, resulting in machine failure;
Do not use the machine without water, it may damage the machine, and it may
be dangerous;
Do not use the machine standing up in order to avoid the danger of falling or
damaging the machine;
Do not operate the machine with wet hands and do not use the machine near
an open fire;
Flush after 10 minutes with white vinegar
09
Advertisement
Table of Contents
