Electrolux ESF4510LOW User Manual page 18

18 www.electrolux.com
Problem and alarm code
The program does not
start.
The appliance does not fill
with water.
The display shows
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and
starts more times during
operation.
The program lasts too
long.
The remaining time in the
display increases and
skips nearly to the end of
program time.
The options of the program
have to be set again every
time.
Small leak from the appli‐
ance door.
Possible cause and solution
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance has started the procedure to recharge
the resin inside the water softener. The duration of
the procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
.
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog‐
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clog‐
ged.
.
• Make sure that the interior filter system is not clog‐
ged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Serv‐
ice Centre.
.
• It is normal. It provides optimal cleaning results and
energy savings.
• An energy-saving option has been selected.
• If the delayed start option is set, cancel the delay set‐
ting or wait for the end of the countdown.
• This is not a defect. The appliance is working cor‐
rectly.
• To save your favourite configuration use option My‐
Favourite.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).