Print Troubleshooting; Software Setup - HID Omni-ID Custom ZT410 User Manual

IQ On Metal Labels User Guide and FAQ
Regional­tag­–­IQ­350
Supplied as standard with Ground Plane and Monza R6-P IC
Issue
Labels won't feed
Barcode not straight
No print at all
Partial print on one side
Print blurring
Print too light
Printer missing tag between each
printed tag.
Sofware­Setuo
Recommended software for Custom Zebra ZT410 is either NiceLabel Pro or Bartender. Please Refer to the software's user guide for
detailed instructions.
http://www.nicelabel.com/downloads/user- guides
https://www.seagullscientific.com/downloads/label- software-case- studies- and- white- papers/-tab4
Possible Cause
Sensor location Sensor setting Media
Calibration
Labels slipping
Ribbon in upside down Wrong ribbon
Head pressure
Too much ink
Too little ink
Gap Levels Incorrect
omni-id.com
Solution
Re- locate sensor Check gap sensing in
menu Re- calibrate media if necessary.
Increase head pressure or change
roller under head
Turn ribbon around Change ribbon to
known good ribbon.
Re- balance
Reduce darkness
Increase darkness Slow print speed
Increase head pressure both sides.
Re calibrate Gap Levels
7