Table of Contents
Advertisement
4-5-3. How to puncture using MP-2458
(1) Attach the transducer cover to the probe according to Section 4-5-1 and then withdraw it to the side
of probe front mark.
(2) Attach the puncture adapter according to instruction manual of the puncture adapter.
(3) Verify the puncture needle does not touch the transducer cover.
Puncture needle
(4) Verify that there is nothing wrong with the transducer cover before puncturing.
Do not use the transducer cover if there is visible damage, such as a tear, and throw away the
transducer cover.
4-5-4. How to remove the puncture adapter (MP-2458)
Remove the puncture adapter from probe according to instruction manual of puncture adapter.
Clean, disinfect and sterilize the puncture adapter immediately after use.
Puncturing root of puncture needle
-25-
Withdraw the transducer cover.
Front mark
Tuck in any part of the transducer cover that may
be protruding and fix it inside puncture adapter
to prevent the contact of the puncture needle tip
to the transducer cover
MN1-5531 Rev. 10
Advertisement
Table of Contents
