Advertisement
Operation
Operating Instructions
Dis-
Func-
play
tion
Power /
A
-
Standby
Flame
+
Up
B
-
Flame
Down
-
Flame
Cycling
-
Off
Sleep
C
Timer
Low
Heat
D
High
Heat
Cool
Blow
-
Off
-
E
Temp Up
-
Temp
F
Down
-
G
10
Description
Press Once to turn the product 'ON'.
Press a second time to p
ss a second time to put the product into 'STANDBY'.
(When returning from 'STANDBY' mode the product will return to previous settings
unless the product has been unplugged, in which case it will reset to factory settings)
The 'FLAME EFFECT' button turns the flame effect ON or OFF independently of the
products other features.
This button will increase the brightness of the flame effect. There are 5 brightness
settings shown as F1, F2, F3, F4 and F5. This button will ONLY increase the bright-
ness level.
This button will decrease the brightness of the flame effect. There are 5 brightness
settings shown as F1, F2, F3, F4 and F5. This button will ONLY decrease the brightness
level.
This setting is set by pressing the 'Flame Up' button once more after F5. This will cause
the brightness of the flame effect to cycle from F2 to F5 in a continuous loop.
This will turn the flame effect off. If the heater is ON, the display will activate and
remain active to read the set temperature and show if the product is on LOW HEAT/
HIGH HEAT or COOL BLOW.
Press multiple times to change the 'SLEEP TIMER' in 0.5hr increments from 0.5 hr to
8hr before turning off. The remaining time on the 'SLEEP TIMER' displays. The icon is
green in colour.
'HEAT' button cycles the unit sequentially through the 4 settings: LOW HEAT, HIGH
HEAT, COOL BLOW and OFF. The heat setting will be indicated by an icon in the display.
When the flame effect is 'ON' the display will turn off after 5 seconds, however if the
heater is being used independently of the flame effect. The low heat or high heat icon
will appear continuously in the display.
This setting will run the heater at 'LOW HEAT' this setting will be indicated by the 'LOW
HEAT' icon and the letters 'LO' appearing in the display. To adjust the temperature
setting the Temp Down or Temp Up buttons described below must be used.
(This icon is Orange in Colour)
This icon in the display indicates 'HIGH HEAT' this setting will be indicated by the 'HIGH
HEAT' icon and the letters 'HI' appearing in the display. To Adjust the temperature
setting the Temp Down or Temp Up buttons described below must be used.
(This icon is Red in Colour)
This icon in the floating display indicates 'COOL BLOW' this setting will be indicated
by the 'COOL BLOW' icon and the letters 'CB' appearing in the display.
(This icon is Blue in Colour)
This switches the heater and blower 'OFF', no icon will be displayed in the display.
Note the blower will run for 5-10 seconds after being turned off, this is to ensure the
product cools down safely.
Press multiple times to increase the heater temperature in 1
highest temperature that can be set 30
When High Heat is selected, the letters 'HH' appear in the display, this means that
heat will remain ON continuously and is not controlled by the thermostat.
Press multiple times to lower the heater temperature in 1
temperature that can be set is 18
The 'Top Light' button turns the top light ON or OFF independently of the products
other features.
0
C.
0
C increments. The lowest
0
C.
0
C increments. The
Advertisement
