La Crosse Technology WS-2510 Commissioning Instructions page 2

Installing the sensors
The installation of the sensors is described in detail in the operating instructions. However, before finally installing the
sensors in the desired location, it should be checked by means of a temporary installation that good reception of the radio
transmission from the sensors is possible in your selected location for the base unit. The base unit must be reset by
removing all 4 batteries. To re-initialize the base unit, the batteries must be replaced after 30 seconds at the earliest.
It can now be checked whether the radio transmission works correctly at the desired point of installation.
Interference can often be rectified by changing the position of individual sensors slightly. Possible causes can also be
found in the Operating Instructions.
Step 5
Activating the wireless brightness sensor by inserting the associated
round bar magnet.
Step 6
Test mode
Immediately after being put into operation, all sensors work for up
10 Minutes
to 10 minutes in a test mode where data is transmitted every 4 seconds
instead of on a 3 minute cycle.
Step 7
Commissioning the base unit is carried out by fitting the 4 C cell
batteries in the battery compartment on the back of the unit. A short
initialization phase takes place during which all segments of the
display come on. No controls may be activated (touch panel)
before this.
After the segment test, the WS 2510 switches automatically to a
search mode, in which every piece of data received is indicated on
the display and is acknowledged by a signal tone. As the display cycles
through each wireless sensor, only the last sensor received is
displayed each time, while the data from all the sensors that have
been received previously are removed from the screen. In this way, it
can be checked quickly and easily that data is being received correctly
from the sensors. After approx. 35 minutes, the search mode for the
base station is automatically terminated and it switches over to
normal receiving mode. Test mode can also be terminated earlier
by pressing any part of the touch panel.
In order to ensure that the sensor data is assigned correctly, the
search mode of the base station should only be terminated when
no more sensors are in test mode.
Correct weather forecasting by displaying the weather symbols will
only occur after a few days when the air pressure characteristic
has been monitored for a sufficient period of time.