Advertisement
Quick Links
Sauna Control Models Pure 2.0
(Type # 1601-40 and 1601-40-1)
Read all instructions carefully before installation. Please leave all
instructions and warranty with the owner.
WARNING
Prolonged exposure to elevated temperatures is capable of inducing
hyperthermia. Hyperthermia occurs when the internal temperature of the
body reaches several degrees above the normal body temperature of
98.6°F. The symptoms of hyperthermia include an increase in the normal
temperature of the body, dizziness, lethargy, drowsiness, and fainting. The
effects of the hyperthermia include failure to perceive heat, failure to
recognize the need to exit the room, unawareness of impending hazard,
fetal damage in pregnant women, physical inability to exit the room and
unconsciousness.
WARNING
The use of alcohol, drugs, or medication is capable of greatly increasing
the risk of fatal hyperthermia.
SECTION 1: GENERAL INFORMATION
The controls are ETL approved by Intertek for permanent installations and
electrical connections. Refer to the heater or steam generator "Installation
and Operation Instructions" for complete information about the electrical
wiring. All wiring must be performed in accordance with national and local
codes.
72-0134
11-26-2019
OPERATING INSTRUCTIONS
WARNING
Do not take a sauna if using
alcohol, drugs or
medications.
Pregnant women or persons
with poor health should
consult their physician before
using any sauna.
Caution re hazard: Do not
use the sauna room for
drying clothes, bathing suits,
etc. Do not hang towels
above heater or place any
object other than the rocks
supplied on the heater. If any
darkening of the wall around
the heater is noticed
discontinue sauna use
immediately.
Inspect sauna regularly for
required maintenance to
heater, control and benches.
Replace wood surfaces
which show any signs of
deterioration.
The heater gets extremely hot
during operation and should
not be touched or burns may
result.
Minors should be adequately
supervised whenever near a
hot or warming sauna.
Page 1
Rev A
Advertisement
Related Manuals for TyloHelo 1601-40
Summary of Contents for TyloHelo 1601-40
- Page 1 If any darkening of the wall around Sauna Control Models Pure 2.0 the heater is noticed (Type # 1601-40 and 1601-40-1) discontinue sauna use immediately. Read all instructions carefully before installation. Please leave all Inspect sauna regularly for instructions and warranty with the owner.
- Page 2 Packing the rocks too tightly may cause the heater high (Control 1601-40-1) Usage time is 0-24 hours operation (Setting 1 = 2 limit switch to trip. hours, setting 10 = 24 hours) version has a maximum sauna length of 24 hours and can be used only when a facility has an attendant on duty to monitor the people in the sauna .
- Page 3 OPERATING INSTRUCTIONS Page 3 SECTION 2: OPERATION, Continued FAHRENHEIT or CELSIUS: The temperature will be displayed in Fahrenheit as default. To change the temperature display, apply power to the system for over 5 minutes and the LED temperature indicator must be glowing. Next, press the < button for 5 seconds.
- Page 4 OPERATING INSTRUCTIONS Page 4 SECTION 4: TROUBLESHOOTING Control will Run but No Heat - Press the (reset) high limit switch on the bottom of heater. Slow Heat Time or High Limit Tripping - Check rock placement, they will break down over time and reduce the air ow in the heater.
Need help?
Do you have a question about the 1601-40 and is the answer not in the manual?
Questions and answers