Advertisement
SI-916 i-003R1 / SI-915 i-003R2
SI-912 i-004R3 / SI-912-018R4 /
SI-914-020R4
3) Accomplishment/Instructions
-
ROTAX
become necessary due to this standardization, at the time of next revision or issue.
NOTE:
Accomplish-
All measures must be implemented and confirmed by at least one of the following persons or
ment
organizations:
-
ROTAX
-
ROTAX
-
Persons approved by the respective Aviation Authorities
-
Persons with approved qualifications for the corresponding engine types. Only authorized per-
sons (iRMT, Level minimum 9-Series Service) are entitled to carry out this work
-
Persons with type-specific training
General
Further material on general inspection, maintenance and repair can be found also in relevant
Advisory Circular AC 43.13 from FAA.
Advisory
This Advisory Circular (AC) contains maintenance methods, techniques and practices.
Circular
3.1) Illustrated Parts Catalog - related information
3.2) Installation - related information
m
m
Proper design of oil line connections and setup for purging the oil system
02 July 2021
Revision
Copyright - BRP-Rotax GmbH & Co KG. All rights reserved.
reserves the right to make any amendments to existing documents, which might
®
Before maintenance, review the entire documentation to make sure you have a com-
plete understanding of the procedure and requirements.
- Airworthiness representatives
®
- Authorized Distributors or their independent Service Centers
®
All work has to be performed in accordance with the relevant ROTAX
Continued Airworthiness (ICA) of the respective engine type.
See current Illustrated Parts Catlog (IPC) for the respective engine type.
As the lubrication system design is also airframe related, also consult the
WARNING
WARNUNG
aircraft manufacturer for proper procedures of purging and venting. All oil
system related parts which are not in the scope of engine supply have to
be evaluated for proper purging and venting by the aircraft manufacturer.
See Chapter 79-00-00 of the current Installation Manual (IM) for the respective engine
type.
SERVICE INSTRUCTION
Instructions for
®
.
79-00-00
Page 4 of 15
Advertisement
