Power Supply Connection - AFIRE BL 40 User Manual

5

5. POWER SUPPLY CONNECTION

An adapter is provided with your device: INPUT 100-240 volts 50/60 Hz and OUTPUT 12 volts 7A.
Before positioning, the device must be connected with the supplied adapter to the power supply.
(picture 1).
Picture 1
If you want to connect your device to a remote command (home automation, etc.), you must use the
"dry contact" connection (picture 2).
WARNING. This connection is planned without polarity and electric tension (0 volt) and amperage (0
A). Warning if you use a tension the electronic board will be damaged.
Picture 2
6. FILLING OF THE TANK:
To open the door of the tank, press on the left switch on the top plate of the burner
and open the door immediately. (Refer to instruction of use 7)
• NEVER fill the burner directly ALWAYS to fill the tank.
• Use only the ethanol fuel minimum 95% (combustible warning paragraph 1)
• If the burner is too hot, the door will not open (Error message E2 or E3). Wait until the temperature
decrease.
• Remove the cap, fill the tank carefully with a funnel (Diameter of the low maximum 15 mm) without
overflowing.
• Don't smoke, switch off your mobile phone.
• Stop the filling as soon you hear a BIP emitted by the electronic gauge (Message E1 on the display).
It is recommended to full the tank for the first use.
• Close the bottle and take it away far from the device. Put back the cap and close the trapdoor of the
device
AFIRE 6 London Street, Paddington, W21HR LONDON, UK