Table of Contents
Advertisement
Quick Links
Page #: 1 of 21
Document #: 4100022
Revision: F
USD 3185
Magnetic Mixer
Single-Use Mixing System
OPERATOR MANUAL
DU005-US, DU006-EU, DU006-UK, DU006-SW, DU006-JP,
DU006-AU
Pall Life Sciences. USA: Port Washington, NY, USA 1 800 717 7255 toll free (USA),+1 516 484 5400 phone,
biopharm@pall.com e-mail, www.pall.com. Europe: Fribourg, Switzerland +41 (0)26 350 53 00 phone,
LifeSciences.EU@pall.com e-mail. Asia-Pacific : +65 6389 6500 phone, sgcustomerservice@pall.com e-mail
© 2012, Pall Corporation. Pall, Allegro, Kleenpak, Stax and the Allegro Design are trademarks of Pall Corporation. ®
indicates a trademark registered in the USA and TM indicates a common law trademark.
Filtration.Separation.Solution is a service mark of Pall Corporation.
Advertisement
Table of Contents
Related Manuals for Pall DU005-US
Summary of Contents for Pall DU005-US
- Page 1 DU005-US, DU006-EU, DU006-UK, DU006-SW, DU006-JP, DU006-AU Pall Life Sciences. USA: Port Washington, NY, USA 1 800 717 7255 toll free (USA),+1 516 484 5400 phone, biopharm@pall.com e-mail, www.pall.com. Europe: Fribourg, Switzerland +41 (0)26 350 53 00 phone, LifeSciences.EU@pall.com e-mail. Asia-Pacific : +65 6389 6500 phone, sgcustomerservice@pall.com e-mail ©...
- Page 2 Document #: 4100022 Revision: F Page #: 2 of 21 Safeguards and Precautions 1. Read and follow all instructions in this manual carefully, and retain this manual for future reference. Operation manual can be provided electronically in alternate languages upon request. 2.
- Page 3 Document #: 4100022 Revision: F Page #: 3 of 21 CAUTION Disconnection of the Protective Earth Connector may impair the protection provided by the system ATTENTION Mains outlet used to power the equipment must be within 3 meters of the device and easily accessible EXPLANATION OF SYMBOLS WEEE: Waste of Electrical and Electronic Equipment...
-
Page 4: Table Of Contents
Document #: 4100022 Revision: F Page #: 4 of 21 1. TABLE OF CONTENTS 1. TABLE OF CONTENTS ................... 4 2. SPECIFICATIONS ....................5 3. INTRODUCTION & PRINCIPLE OF OPERATION ..........5 4. ELECTRICAL SCHEMATIC ..................6 5. MAGNETIC MIXER SYSTEM COMPONENTS ............8 6. -
Page 5: Specifications
4. Accessory kit for interfacing the drive with the tank and bag The Magnetic Mixer reusable system can accommodate a variety of standard and custom- ® designed disposable bags and tanks available from Pall Lifesciences with a capacity range from 30L to 2000L. -
Page 6: Electrical Schematic
Document #: 4100022 Revision: F Page #: 6 of 21 4. ELECTRICAL SCHEMATIC 115 VAC:... - Page 7 Document #: 4100022 Revision: F Page #: 7 of 21 230 VAC:...
-
Page 8: Magnetic Mixer System Components
Document #: 4100022 Revision: F Page #: 8 of 21 MAGNETIC MIXER SYSTEM COMPONENTS Figure 1: Main components of the Magnetic Mixer disposable mixing system (shown with 500L tank). -
Page 9: Magnetic Mixer System Accessories
Document #: 4100022 Revision: F Page #: 9 of 21 5. MAGNETIC MIXER SYSTEM ACCESSORIES Interface with O-ring: The Interface provides mechanical interfacing of the drive unit with the impeller inside the bag. Figure 2: Top: Drive-bag interface and O-ring. Bottom: Interface is installed in the railed port of the dolly (locked by the O-ring). - Page 10 Document #: 4100022 Revision: F Page #: 10 of 21 Centering Aligner and Magnetic Clamp: The Centering Aligner maintains centered position of the impeller with respect to the interface. The Magnetic clamp provides holding function for the bag in the tank before the fluid is put inside the bag. After the fluid is filled to at least a level of 3”, the magnetic clamp can be removed as the hydrostatic pressure from fluid will hold the bag in place.
-
Page 11: Dolly - Tank Assembly
Document #: 4100022 Revision: F Page #: 11 of 21 6. DOLLY - TANK ASSEMBLY Note: Certain larger tanks (>350L) are constructed in two parts. 7.1. The Dolly has a pre-cut hole over the drive port. Insert the Interface into this hole from below and apply the O-ring as shown (see ) to secure. -
Page 12: Bag - Interface Assembly
Document #: 4100022 Revision: F Page #: 12 of 21 7. BAG - INTERFACE ASSEMBLY Figure 5: Assembly of dry bag with interface 8.1 Carefully open the EXTERNAL packaging of the mixing bag. A blue protective shell is magnetically attached to the outside of the bag over the locator. This shell must be removed from the bag before assembling the interface. -
Page 13: Inserting Plastic Bag Into Tank
Document #: 4100022 Revision: F Page #: 13 of 21 8. INSERTING PLASTIC BAG INTO TANK Figure 6: Bag-Tank Assembly 9.1 Place the bag in the plastic tank by aligning magnetic clamp with the large pre-cut port on the bottom surface of the tank and pull the bottom drain tube through the smaller port. -
Page 14: Coupling The Bag With The Drive Unit
Document #: 4100022 Revision: F Page #: 14 of 21 9. COUPLING THE BAG WITH THE DRIVE UNIT Figure 7: Coupling of magnetic mixer drive with the bag can be accomplished only when the bag is filled with fluid (No coupling should be attempted with an empty or dry bag! The impeller will damage the bag.) 10.1 Remove Magnetic Clamp from the bag-tank assembly before coupling. -
Page 15: Drive Motor Operation
Document #: 4100022 Revision: F Page #: 15 of 21 10.6 Using the drive unit handle, raise the superconductive drive unit to an upright position. While holding the drive unit in this position shift the latch toward the dolly/tank so that the cross bar rests on the grooves in the guide rails (as shown in the forth segment of Figure 7). -
Page 16: Disconnecting Drive Unit From Tank
Document #: 4100022 Revision: F Page #: 16 of 21 11. DISCONNECTING DRIVE UNIT FROM TANK 12.1 When mixing is complete, turn the RPM Regulator to zero (0) and turn the drive switch to the STOP position. (Ensure that electrical power remains connected to the machine when mixing multiple bags consecutively.) 12.2 Firmly hold the drive unit handle and raise the drive unit slightly to release the locking... -
Page 17: Ezd Operating Instructions
Document #: 4100022 Revision: F Page #: 17 of 21 12. EZD OPERATING INSTRUCTIONS WARNING: EZD Clip (4100153) must be installed on the bag before operating EZD valve or bag can be damaged EZD stands for Easy Drain meaning a drain that allows easy transfer of fluid to and from the container. - Page 18 Document #: 4100022 Revision: F Page #: 18 of 21...
-
Page 19: Atmi Lifesciences - Service
The Magnetic Mixer system was developed exclusively for mixing fluids and solids into fluids in specially designed disposable bags. Only use the Magnetic Mixer for these applications to ensure a long service life. Should your Magnetic Mixer require service, contact: North America: PALL Life Sciences 20 Walkup Drive Westborough, MA 01581 E-mail: PASS_Support@pall.com Europe:... - Page 21 Revision: F PAGE INTENTIONALLY LEFT BLANK Pall Life Sciences. USA: Port Washington, NY, USA 1 800 717 7255 toll free (USA),+1 516 484 5400 phone, biopharm@pall.com e-mail, www.pall.com. Europe: Fribourg, Switzerland +41 (0)26 350 53 00 phone, LifeSciences.EU@pall.com e-mail. Asia-Pacific : +65 6389 6500 phone, sgcustomerservice@pall.com e-mail ©...