JVC CL-R813 Instruction Manual page 12

The model CL-R813 is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the model CL-R813 can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and the model CL-R813 as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.
NOTE 3 The screen of EUT flickers during testing, but it is self-recoverable after test.
NOTE 4 The EUT was stopped operating during the test, but it is self-recoverable after test.
Cables used for the test
AC Power Cord
DisplayPort Cable
DVI Cable
USB Cable
ENGLISH
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d = 1.2
0.12
0.38
1.2
3.8
12
- 12 -
m
80 MHz to 800 MHz
d = 1.2
0.12
0.38
1.2
3.8
12
Length
3.0 m
3.0 m
3.0 m
3.0 m
800 MHz to 2.7 GHz
d = 2.3
0.23
0.73
2.3
7.3
23