Advertisement
Pair the wireless, batteryless switch to control the connected roller shutter switches
2
Make sure that the indicator lights on the wired products are green.
If not, go back to precedent step.
Tap 3 times the roller shutter switch you want to control with the wireless, batteryless control. The light of the
A
roller shutter switch flashes rapidly.
B
While pressing the «setup» button, press briefly the «Stop» or «Up» or «Down» button.
C
The indicator lights of the product to control will briefly turn blue, and then will turn green again.
The pairing was successful.
Check the correct pairing by pressing Up and then Down buttons
Multiple pairing : You can control several roller shutter switches with the same wireless, batteryless switch by
repeating the operation for each product that you want to control.
3
Complete the installation
< 1 s
To complete your installation, briefly press the configu-
ration of the Module Control or the middle of the wire-
less Home / Away master switch.
All the indicator lights on the products switch off.
.
1
A
Or
< 1 s
C
If necessary, erase the configuration of the wireless
batteryless control (factory reset)
+
While holding the "setup" button on the wireless,
batteryless control, press the "Up" button for 5 seconds.
Confirm that your control is correctly reset by making an
Up command, then Down.
3
B
+
5 s
Advertisement
