Snailax SL-233G Use & Care Manual page 4

Setup and Opera�on
1. A�ach the massager to a chair with elas�c straps or place it on other support.
2. Connect the adapter cable to the corresponding cable on the cushion.
3. Plug the home adapter into an outlet.
4. Turn on the device using the controller ( instruc�ons on page 5 ).
5. When finished place the controller in the pouch at the side of the cushion.
6. Detachable intensity control flap for back lets you choose a so�er or more intense massage.
7. Detachable cover for neck lets you choose a so�er or more intense massage.
! A�en�on
If the Shiatsu is too strong,
① Install the flap onto the cushion to get a so�er massage.
② Place a blanket or towel between you and the massager to achieve a far
so�er massage intensity if you s�ll feel too strong shiatsu a�er installing
the flap onto the cushion.
If the shiatsu can't reach your neck,shoulder or lower back area
③ If you want to massage your neck, shoulder, lower back, but the shiatsu nodes can not
reach the area in need, you may adjust the height of your back when si�ng, by placing
a seat cushion or a pillow on the si�ng part.
①
• The device will automa�cally switch off a�er 15 minutes �mer run out.
• Remove the adapter from the outlet when not in use.
• Do not setup or use the massager in a bathroom or similary wet / damp areas.
• Do not use this device while driving.
!A�en�on
• You should allow your body some rest periods. To avoid straining your muscles
too much, we recommend to Not exceed a con�nuous massage of 15 Minutes
per �me and Not exceed 3 �mes use one day.
Blanket
/Towel
Removable
ap
Seat cushion
②
4
③