Advertisement
Quick Links
Installation and User Guide
P
P
™
P
P
™
R
E
S
E
N
T
E
R
O
D
R
E
S
E
N
T
E
R
O
D
Preset Trigger System for the Vaddio™ Automated Content Presentation
Systems
Part Numbers:
999-1111-000 North America
999-1111-001 International
©2011 Vaddio - All Rights Reserved
PresenterPOD System
Document Number 342-0212 Rev. B
●
●
Advertisement
Related Manuals for VADDIO PRESENTERPOD 999-1111-000
Summary of Contents for VADDIO PRESENTERPOD 999-1111-000
- Page 1 Installation and User Guide ™ ™ Preset Trigger System for the Vaddio™ Automated Content Presentation Systems Part Numbers: 999-1111-000 North America 999-1111-001 International ©2011 Vaddio - All Rights Reserved PresenterPOD System Document Number 342-0212 Rev. B ● ●...
- Page 2 PresenterPOD System Inside Front Cover -Blank PresenterPOD System Document Number 342-0212 Rev. B Page 2 of 12 ●...
- Page 3 Read and understand all instructions before using. Do not operate any device if it has been dropped or damaged. In this case, a Vaddio technician must examine the product before operating. To reduce the risk of electric shock, do not immerse in water or other liquids and avoid extremely humid conditions.
- Page 4 PresenterPOD System Unpacking: Carefully remove the products and all of the parts from the packaging. Part Number 999-1111-000 (North America) • One (1) PresenterPOD Interface 998-1111-000 • One (1) PresenterPOD 998-1111-002 with Hardware o Two (2) Metal Wall Mount Tabs o Two (2) 6-32 x 5/16”...
- Page 5 PresenterPOD System The PresenterPOD Interface - Single PresenterPOD System (no scale) ➑ ➊ ➎ ➋ ➌ ➍ ➏ ➐ Cat-5e Cable PresenterPOD 1 (no scale): Buttons marked to correspond to the icons on the Trigger Outs of PresenterPOD 1. The PresenterPOD is connected to the POD 1 Interface with a Cat-5e cable (up to 100’...
- Page 6 PresenterPOD System PresenterPOD I/O The PresenterPOD has two (2) RJ-45 connection Bottom of the PresenterPOD points for flexibility in mounting and cabling. Use only one of these connectors at a time. The Cat-5e Rubber cable between PresenterPOD Feet x 4 PresenterPOD Interface carries power to the POD and exchanges data with the interface.
- Page 7 Once the PresenterPOD is connected to the PresenterPOD Interface, the triggers can be connected to the device to be activated (AutoPresenter, ControlVIEW XHD, Hot-Shot Preset Camera Controller, ProductionVIEW HD or other control systems). In this example, the Vaddio AutoPresenter is shown below. PresenterPOD 1 PresenterPOD Interface Cat-5e Cable up to 100’...
- Page 8 100’ (30.48m) Basic System Connectivity Example 2: This system configuration uses two (2) PresenterPODs and one PresenterPOD Interface to trigger the Vaddio AutoPresenter at two different locations (Video Whiteboard and at the Instructor’s Lectern) in a presentation or videoconferencing room.
- Page 9 Vaddio Customer Service: Vaddio will test, repair, or replace the product or products without charge if the unit is under warranty and is found to be defective. If the product is out of warranty, Vaddio will test then repair the product or products. The cost of parts and labor charge will be estimated by a technician and confirmed by the customer prior to repair.
- Page 10 Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s authority to operate this equipment.
- Page 11 PresenterPOD System PresenterPOD System Notes: PresenterPOD System Document Number 342-0212 Rev. B Page 11 of 12 ●...
- Page 12 Toll Free: 800-572-2011 ▪ Phone: 763-971-4400 ▪ FAX: 763-971-4464 www.vaddio.com ©2011 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing are subject to change without notice. Vaddio, PresenterPOD, EZCamera, WallVIEW, AutoPresenter, Hot-Shot, Squiggle, ControlVIEW, ProductionVIEW, ClearVIEW, Quick-Connect and PowerRite are trademarks of Vaddio.
Need help?
Do you have a question about the PRESENTERPOD 999-1111-000 and is the answer not in the manual?
Questions and answers