Related Manuals for TECNARE ARRAY Series
Summary of Contents for TECNARE ARRAY Series
- Page 1 Operation Manual ARRAY Series CLa208 Curvilinear Array Loudspeaker Keep these important operating instructions. Check www.tecnare.com for updates.
- Page 3 EXEL ACOUSTICS SL CL Encinar, 282 – Pol. Ind. Monte Boyal 45950 Casarrubios del Monte (Toledo) Spain Phone: (+34) 918 170 110 Fax: e-mail: support@tecnare.com www.tecnare.com...
-
Page 4: Important Safe Instructions
Operation Manual IMPORTANT SAFE INSTRUCTIONS Before using our product, be sure to carefully read the manual and safe Instructions. Keep this document with the device all time. Read these instructions. several enclosure on top of one another, use straps to secure them against movement. Keep these instructions. - Page 5 Operation Manual SYMBOLS USED OBLIGATION.This Important operating Additional instructions must instructions information be strictly followed Obligation. Cela Pour indequer important Information doit être Instructions complémentaire strictement instructions Suivi Wichtige Pflicht. Diese Betriebsanweisung Informationen. Anweisungen oder Zusätzliche müssen strikt Gebrauchsanleitung Informationen befolgt sanleitung Obligación.
-
Page 6: Declaración De Conformidad
Operation Manual DECLARACIÓN DE CONFORMIDAD DECLARATION OF CONFORMITY EXEL ACOUSTICS SL CL Encinar, 282. Polígono Industrial Monte Boyal. 45950 – Casarrubios del Monte (Toledo), España (Spain). Declara que el producto CLa208 y sus respectivas opciones, cumple con las Directivas: Declare under our sole responsibility that devices in the CLa208 range of products, comply with relating Directives: (1) Directiva de Baja Tensión - 2006/95/CE (2) Directiva de Compativilidad Electromagnética - 2004/108/CE... -
Page 7: Table Of Contents
Table of Contents Table of Contents IMPORTANT SAFE INSTRUCTIONS..................3 DECLARACIÓN DE CONFORMIDAD ..................5 Introduction ........................7 Welcome to Tecnare ....................7 Overview the CLa208 ....................8 Connections ......................9 Processing and Amplification..................9 Loudspeaker Configuration..................11 Standalone......................11 Line Source and Subwoofer..................12 Loudspeaker Connection ....................13 Connecting CLa208 to PA2100 & PA900..............13 Connecting CLa208 to PA2100 &... -
Page 8: Introduction
All Tecnare products are carefully engineered for world-class performance and reliability. ® If you would like further information about this or any other Tecnare product, please contact us. We look forward to helping you in the near future. As part of a continuous evolution of techniques and standards, Exel Acoustics ®... -
Page 9: Overview The Cla208
SW-118M or SW-218V/EB subwoofers and is designed to integrate smoothly and easily with other Tecnare products. While CLa208 can be used as a main system, individual CLa208 cabinets work well for under-balcony coverage and frontfill. Also, Cla208 is an excellent downfill or sidefill complement to a CLa21 or CLa312 main system for tours playing a variety of venues. -
Page 10: Connections
1.4.2 Amplification To power Array Series, Tecnare recommends amplifiers with the power ratings enough to feed the loudspeakers. For high power or live applications, it is recommended to oversize the amplifiers relative to the nominal AES output of the subwoofers. - Page 11 In certain specific cases it is possible to slightly under-power the subs or loudspeakers as long as the amplifier will not be driven to its limits. In any case, the Tecnare processors should be deployed in front of the amp to ensure that the amplifiers to not go into clip.
-
Page 12: Loudspeaker Configuration
Operation Manual Loudspeaker Configuration The CLa208 loudspeaker employs a combination of drivers to enable you to optimiza both coverage and directivity in a CLa208 line source system. Deployed as stand alone line source, the CLa208 system can be operate over the nominal bandwidth of the CLa208 enclosure 62 Hz- 18KHz. -
Page 13: Line Source And Subwoofer
CLa208 loudspeaker array. Tecnare SW118M, SW218V or SW218EB can achieve frequency response down to 30 to 45 Hz range, extending the low-end bandwidth. Preset for DP-Series processor and T-Series amplifier are available for different configuration and applications. -
Page 14: Loudspeaker Connection
Tecnare loudspeaker controllers. ® Tecnare only recommends using preset/amplifier developed by Tecnare, otherwise there is a risk of damaging the loudspeaker components. DP Series Loudspeaker Controller, PA Series amplifier and T-Series amplifier are ideal for this purpose. Ensure that the right preset was selected before connecting the loudspeaker with the amplifier. -
Page 15: Connecting Cla208 To Pa2100 & Pa4.450
Operation Manual Connecting CLa208 to PA2100 & PA4.450 MAXIMUM OF 2 ENCLOSURES PER PA2100 (LF) / 4 ENCLOSURES PER PA4.450 (HF) 2 x CLa208 can be connected in parallel to each pair of output channels on the PA2100 and PA4.450 amplifiers. Impedance load: 1 Enclosure →... -
Page 16: Connecting Cla208 To T-Series
Operation Manual Connecting CLa208 to T-Series MAXIMUM OF 8 ENCLOSURES PER T-SERIES 4 x CLa208 can be connected in parallel to each pair of output channels on the T-Series amplifiers. Impedance load: 1 Enclosure → LF: 8Ω; HF:16Ω 2 Enclosures → LF: 4Ω; HF:8Ω 4 Enclosures → LF: 2Ω; HF:4Ω... -
Page 17: Integrating Cla208
Integrating SW-118M subwoofer with CLa208 Curvilinear Array Loudspeaker A CLa208 array can be deployed in combination witn Tecnare SW-118M subwoofer in applications were LF reinforcement is needed. When fitted with rigging hardware, SW-118M subwoofers may either be ground stacked, flown as part of a CLa208 array, or flown separately alongside a CLa208 array, to boost the system’s low-frequency output and headroom. -
Page 18: Integrating Cla208 As Side-Fill Or Down-Fill With Cla21 Curvilinear Arrays
Configuration For other configuration, it will usually be necessary to determine the signal delay setting by measurement. When loudspeaker and subwoofers are physically separated by more than 1,2m (4feet), or delay ® must be used between them, a measurement system such as SMAART should be used to determine the correct delay and polarity. -
Page 19: Technical Specifications
Technical Specifications Technical specifications ACOUSTICAL 62/80 (1) Hz – 18kHz±4dB (1 box), measured on axys. Recommended operating frequency range. Operating Frequency Range Response depends on loading conditions and room acoustics Note: The low-frequency response of the system will increase according to the length of the array Free Field Frequency 80/90 (1) –... - Page 20 Operation Manual CLa208 Dimensions...
- Page 21 Operation Manual...
- Page 22 Exel Acoustics. Tecnare and PCC-Net are trademarks of Exel Acoustics SL. Podware, BvNet, Smaart and all third-party trademarks mentioned herein are the property of their respective trademark holders.
- Page 23 EXEL ACOUSTICS SL CL Encinar, 282 - Pol. Ind. Monte Boyal 45950 Casarrubios del Monte (To) Spain support@tecnare.com www.tecnare.com - www.facebok.com/tecnare (T): +34 918 170 110 - +34 918 171 001 (F): +34 918 183 053 rev.:2.00 2016...
Need help?
Do you have a question about the ARRAY Series and is the answer not in the manual?
Questions and answers