SMC Networks CF5 Service Manual page 6

14. When oil seal is ins
the oil sea al with the n
outside, an nd check th
installed fo or smoothn
oil seal.
15. Remove re esidues of
reinstallati on, grind w
has any da amage.
16. The ends o of rubber h
should be pushed as
so that the ere is enou
tightening the clamp
17. Rubber an nd plastic b
the origina al correct p
18. The bearin ng tool sho
removing a a ball bear
inner race or outer ra
bearing, us se equal fo
(Bo
All manuals and user guides at all-guides.com
stalled, fill t he groove with greas
name of th e manufac cturer facin
he shaft on n which the e oil seal is
ness and fo or burrs tha at may dam
the old ga asket or sea alant befor
with a grind dstone if th he contact
hoses (for fuel, vacuu um, or coo
s far as the ey can go t to their con
ugh room b below the e enlarged en
s.
boots shou ld be prop erly reinsta
positions as s designed d.
ould be pre essed again nst two (in
ring. Dama age may re esult if the t
ace). In thi s case, the e bearing s
orce on bo th races.
oth of thes se example es can res
SMC MC ATV50 0/100 Se
Chapte
se, install
ng
s to be
mage the
re
surface
olant)
nnections
nds for
alled to
ner and ou uter) bearin ng races w
tool is pres ssed again nst only one
should be r replaced. T To avoid d
sult in bear ring damag
Service M Manual
er 1 Gen eral Inform mation
when
e race (eith her
amaging th he
ge)
- 5 - -